2008

Accelerometer

Dytran Instruments’ 3234A series IEPE accelerometer is available in three versions with varying sensitivities and range. Model 3234A1 is rated 10mV/g, Model 3234A2 is 100mV/g, and Model 3234A3 is 500mV/g.

Suited for modal analysis, NVH, squeak & rattle and general purpose vibration applications, the accelerometer has ultra-low noise electronics, wide bandwidth and all titanium construction. It is also ground isolated. This accelerometer features a 10-32 mounting hole and its cubic design allows for adhesive mounting on multiple mounting faces.

The accelerometer features low impedance voltage mode (IEPE) operation. The self-generating seismic element, utilizing piezoceramic crystals in planar shear mode, converts acceleration to an analogous electrostatic charge mode signal. This very high impedance signal is fed to the input of a miniature on-board IC JFET charge amplifier that drops the output impedance level ten orders of magnitude, allowing this instrument to drive long cables without harming sensitivity and frequency response.

For free info Visit http://info.hotims.com/15128-325

White Papers

Drive On – E-Bikes Shift into High Gear
Sponsored by HP
Step on It! Walking for Power
Sponsored by HP
Antenna Basics
Sponsored by Rohde and Schwarz
Introduction to Hypervisor Technology
Sponsored by Curtiss-Wright Controls Embedded Computing
Windows CE Development for RISC Computers Made Easy
Sponsored by Sealevel
OEM Optical System Development
Sponsored by Ocean Optics

White Papers Sponsored By: