Spatial Combining of Laser-Diode Beams for Pumping an NPRO

Multiple multimode beams are efficiently combined into one optical fiber.

A free-space optical beam combiner now undergoing development makes it possible to use the outputs of multiple multimode laser diodes to pump a neodymium-doped yttrium aluminum garnet (Nd:YAG) non-planar ring oscillator (NPRO) laser while ensuring that the laser operates at only a single desired frequency. This optical beam combiner serves the same purpose as does the one described in “Diffractive Combiner of Single-Mode Pump Laser- Diode Beams” (NPO-42411), NASA Tech Briefs, Vol. 31, No. 5 (May 2007), page 16a. Although the principles of design and operation of the present and prior beam combiners are not identical, they are so closely related that it is necessary to devote the next four paragraphs to reiteration of a substantial portion of the cited prior article in order to give meaning to a description of the present beam combiner.

Heretofore, a Nd:YAG NPRO like the present one has been pumped by a single multimode laser-diode beam delivered via an optical fiber. It would be desirable to use multiple pump laser diodes to increase reliability beyond that obtainable from a single pump laser diode. However, as explained below, simplistically coupling multiple multimode laser-diode beams through a fiber-optic combiner would entail a significant reduction in coupling efficiency, and lasing would occur at one or more other frequencies in addition to the single desired frequency.

Figure 1 schematically illustrates the principle of operation of a laser-diodepumped Nd:YAG NPRO. The laser beam path is confined in a Nd:YAG crystal by means of total internal reflections on the three back facets and an optical coating on the front facet. The wavelength of the pump beam — 808 nm — is the wavelength most strongly absorbed by the Nd:YAG crystal. The crystal can lase at a wavelength of either 1,064 nm or 1,319 nm — which one depending on the optical coating on the front facet.

In order to restrict lasing to a single frequency, it is necessary to confine the pump beam within the region occupied by the TEM00 mode of the NPRO laser beam near the front facet inside the crystal. In practice, this means that the pump beam must be focused to within a given solid angle (Ω) and area (A). [If a given pump beam has a larger A or larger Ω but its AΩ is equal to or less than the maximum AΩ for single-frequency lasing in the crystal, then an imaging lens can be used to trade A against Ω so that both A and Ω are equal to or smaller than the maximum values for single-frequency lasing. It is possible to do this because it is a basic principle of optics that AΩ is preserved in imaging by a lens.]

The AΩ of a commercial multimode 808-nm laser diode of the type used heretofore is not axisymmetric; instead, it is elliptically distributed about the optical axis and, hence, does not match the circular distribution of a multimode fiber of the type used heretofore to deliver a pump beam. As a result of this mismatch, AΩ for the pump beam emerging from the output end of the fiber is increased, typically to near the maximum single-frequency-lasing value in at least one of the planes containing the principal axes of the elliptical distribution. Consequently, it is difficult or impossible to maintain single-frequency lasing when combining the beams from two or more multimode laser diodes.

White Papers

Electroforming Basics
Sponsored by Servometer
High-Speed, Real-Time Recording Systems Handbook
Sponsored by Pentek
Solar Electric Systems – Power Reliability
Sponsored by SunWize
T&M Solutions for Software Defined Radios (SDR)
Sponsored by Rohde and Schwarz A and D
Reliability Testing of GORE® Protective Vents in Telecommunication Enclosures
Sponsored by Gore
Tubing & Hose Buying Tips
Sponsored by Newage Industries

White Papers Sponsored By: