2008

In-Process Detection of Defects During Welding

Technology is required to enable “in-process” or real-time detection of defects during the welding process. This could be achieved by a system that can monitor any combination of accessible parameters during the weld process and then by analyzing changes, ascertain the presence of a weld defect, its locations, and, if possible, its nature. Potential solutions should be suitable for industrial production lines.

Respond to this TechNeed at:
www.techbriefs.com/techsearch/tn/200802c.html
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Phone: 781-972-0600

White Papers

Reverse Engineering
Sponsored by Servometer
Introduction into Theory of Direction Finding
Sponsored by rohde and schwarz a and d
Heavy Duty Shaft Coupling Strategies
Sponsored by ringfeder
Piezo Engineering Tutorial
Sponsored by aerotech
Roller Pinion System: An Alternative to Traditional Linear Drive Systems
Sponsored by nexen
dB or not dB? Everything you ever wanted to know about decibels but were afraid to ask...
Sponsored by rohde and schwarz a and d

White Papers Sponsored By: