2009

Voice Coil Percussive Mechanism Concept for Hammer Drill

A hammer drill design of a voice coil linear actuator, spring, linear bearings, and a hammer head was proposed. The voice coil actuator moves the hammer head to produce impact to the end of the drill bit. The spring is used to store energy on the retraction and to capture the rebound energy after each impact for use in the next impact. The maximum actuator stroke is 20 mm with the hammer mass being 200 grams. This unit can create impact energy of 0.4 J with 0.8 J being the maximum.

This mechanism is less complex than previous devices meant for the same task, so it has less mass and less volume. Its impact rate and energy are easily tunable without changing major hardware components. The drill can be driven by two half-bridges. Heat is removed from the voice coil via CO2 conduction.

This work was done Avi Okon of Caltech for NASA’s Jet Propulsion Laboratory. For more information, contact This email address is being protected from spambots. You need JavaScript enabled to view it.. NPO-45712

White Papers

Recruit Or Retain Report
Sponsored by Aerotek
Bridging the Armament Test Gap
Sponsored by Marvin Test Solutions
Metal Injection Molding Turns the Volume Up, and Down
Sponsored by Proto Labs
Avoid the High Cost of Quality Failure
Sponsored by Arena Solutions
10 Ways to Make Your Wiring and Harness Design Faster and Better
Sponsored by Mentor Graphics
Changing Face of Robotics
Sponsored by Maplesoft

White Papers Sponsored By: