Thin-Film Solid Oxide Fuel Cells

Mass, volume, and the cost of materials can be reduced for a given power level.

The development of thin-film solid oxide fuel cells (TFSOFCs) and a method of fabricating them have progressed to the prototype stage. A TFSOFC consists of the following:

  • A fuel electrode (anode) of nickel or other suitable metal, about 10 micrometers thick, made porous in a required pattern as described below;
  • A solid electrolyte deposited on the anode of 0.5- to 2-micrometer thickness;
  • An oxidizer electrode (cathode) in the form of a layer of a mixed ionic-electronic conductive oxide deposited to a typical thickness between 1 and 10 micrometers on the solid-electrolyte face opposite that of the anode; and
  • An electrically insulating structure that encloses the aforementioned components and includes manifolds for the delivery of fuel to the anode, delivery of air or other oxidizing gas mixture to the cathode, and removal of combustion products.

The porosity of the anode in a TFSOFC is necessary to enable delivery of the fuel to the anode side of the solid electrolyte. The cathode is required to be porous or at least permeable to the oxidizer to enable delivery of oxygen to the cathode side of the solid electrolyte. The solid electrolyte layer is required to be dense and free of defects so that neither the fuel nor the oxidizer leaks through it. The relatively small thickness of the electrolyte also makes it possible to operate the TFSOFC at temperature lower than is necessary for a thickerel-ectrolyte fuel cell of older design. In turn, operation at lower temperature increases the reliability and enables a wider choice of materials for constructing the TFSOFC.

In the fabrication of a TFSOFC, nickel foil to be used as the anode material can be rolled or otherwise processed to produce an ordered crystal structure so that subsequent epitaxial deposition of the solid electrolyte material on the anode will cause the solid electrolyte to be also crystallographically ordered and, therefore, to be dense and relatively free of defects, as required. The epitaxial deposition of the solid electrolyte and the deposition of the electronically and ionically conductive cathode layer on the electrolyte can be effected by any of several established processes for deposition of thin oxide films. After deposition of the solid electrolyte, the required porosity is introduced into the nickel by photolithographic patterning and etching.

White Papers

BioCompatic: LEMO - Northwire's Robust USP Class VI Silicone Alternative
Sponsored by northwire
Molds for Medical Technology
Sponsored by husky
White Papers: Using FPGAs to Improve Embedded Designs
Sponsored by Sealevel
The Self-Driving Car
Sponsored by HP
Lubrication Considerations for Bearings
Sponsored by ast bearings
Performance Characteristics of Digital Frequency Discriminators
Sponsored by Wide Band Systems

White Papers Sponsored By: