2009

CMC face sheets bonded to ceramic foam cores are delamination-resistant and reduce cost, weight, and maintenance.

The use of hybridized carbon/silicon carbide (C/SiC) fabric to reinforce ceramic matrix composite face sheets and the integration of such face sheets with a foam core creates a sandwich structure capable of withstanding high-heat-flux environments (150 W/cm2) in which the core provides a temperature drop of 1,000 °C between the surface and the back face without cracking or delamination of the structure. The composite face sheet exhibits a bilinear response, which results from the SiC matrix not being cracked on fabrication. In addition, the structure exhibits damage tolerance under impact with projectiles, showing no penetration to the back face sheet. These attributes make the composite ideal for leading-edge structures and control surfaces in aerospace vehicles, as well as for acreage thermal protection systems and in high-temperature, lightweight stiffened structures.

alt
The Foam Core Ceramic Matrix Composite is a weave SiC and carbon fiber, which allows heat dissipation inplane. Face sheet thickness is nominally 2.4 mm, and core thickness is 1.26 cm.
By tailoring the coefficient of thermal expansion (CTE) of a carbon fiber-containing ceramic matrix composite (CMC) face sheet to match that of a ceramic foam core, the face sheet and the core can be integrally fabricated without any delamination. Carbon and SiC are woven together in the reinforcing fabric. Integral densification of the CMC and the foam core is accomplished with chemical vapor deposition, eliminating the need for bond-line adhesive. This means there is no need to separately fabricate the core and the face sheet, or to bond the two elements together, risking edge delamination during use.

Fibers of two or more types are woven together on a loom. The carbon and ceramic fibers are pulled into the same “pick” location during the weaving process. Tow spacing may be varied to accommodate the increased volume of the combined fiber tows while maintaining a target fiber volume fraction in the composite. Foam pore size, strut thickness, and ratio of face sheet to core thickness can be used to tailor thermal and mechanical properties. The anticipated CTE for the hybridized composite is managed by the choice of constituents, varying fiber tow sizes and constituent part ratios.

This structural concept provides high strength and stiffness at low density — 1.06 g/cm3 in panels tested. Varieties of face sheet constructions are possible, including variations in fiber type and weave geometry. The integrated structures possible with this composite could eliminate the need for non-load-bearing thermal protection systems on top of a structural component. The back sheet can readily be integrated to substructures through the incorporation of ribs. This would eliminate weight and cost for aerospace missions.

This work was done by Frances I. Hurwitz of Glenn Research Center.

Inquiries concerning rights for the commercial use of this invention should be addressed to NASA Glenn Research Center, Innovative Partnerships Office, Attn: Steve Fedor, Mail Stop 4–8, 21000 Brookpark Road, Cleveland, Ohio 44135. Refer to LEW-18126-1.

White Papers

The Simple Guide to a Life Science Recall
Sponsored by Verse Solutions
High-Performance MEMS IMU Solutions for Demanding Applications
Sponsored by Avnet
Power Control For Automotive Applications
Sponsored by Maxim Integrated
Simulating Composite Structures
Sponsored by ANSYS
Antenna Basics
Sponsored by Rohde and Schwarz AD
Addressing Security Vulnerabilities at the Source
Sponsored by PRQA

White Papers Sponsored By:

The U.S. Government does not endorse any commercial product, process, or activity identified on this web site.