2010

Monitoring Carbon Composite Structures With Optical Fiber Sensors

Rayleigh Scatter Sensing

altaltA new technique called Rayleigh scatter sensing addresses this issue by allowing the entire length of integrated fiber to act as a sensor. Rayleigh scatter sensing uses a technique called optical frequency domain reflectometry (OFDR) to measure the distributed amplitude and phase of the Rayleigh scatter signature produced by standard optical fiber. This signature is very weak, reflecting less than one part per billion in optical probe power, but it is present in all optical fiber and forms an ideal sensing mechanism.

altSimilar to interrogating FBGs, the Rayleigh backscatter of a fiber creates a unique pattern that is measured by the instrument. Instead of a clear peak or set of peaks, however, the reflected amplitude, phase and spectrum of the scatter are random patterns from inherent variations in standard telecommunication fiber. Just as with an FBG, applied temperature or strain shifts the reflected spectrum of the scatter in the fiber at the location it is applied. Nominally, the shift in reflected spectrum in an FBG is found by measuring the shift in its spectral peak. Finding the frequency shift of the scatter spectrum is slightly more complicated as the spectrum is random. This is accomplished by performing a cross-correlation of the scatter spectrum from a measurement data set with that from a reference data set taken with the fiber under test in some nominal temperature or strain state.

Both very large and very small strains can be detected with high precision by comparing the phase changes along the length of the fiber. Figure 3 shows strain data collected from a fiber zig-zag pattern integrated into a composite laminate (Figure 4). Strain data show delamination in the center of the composite article.

While there are many benefits that fiber sensors bring to structural monitoring of composite materials, they also present very specific challenges. From a material perspective, the use of fiber sensors often introduces another new material with which engineers, scientists and technicians often have limited experience. Installation of optical fiber such that the sensors are both robust and accurate requires training and know-how. While optical fiber itself, when handled and installed properly, is quite robust, ingress and egress points present a particular challenge when integrating optical fiber with composite structures. Improper treatment of these locations can lead to short sensor life. Finally, fiber sensors — in particular the new Rayleigh method highlighted here — produce large quantities of data. This causes not only a data management issue but presents a broader challenge of what types of decisions should be made based on what can potentially be “too much” data. Ultimately, of course, more of the right kind of data is only a good thing.

From a structural health monitoring perspective, optical fiber offers a unique opportunity in the deployment of smarter, lighter and stronger composite structures. Rayleigh sensing stands out among promising techniques due to extremely high resolution, large dynamic range, and lack of sensor placement issues. Furthermore, standard telecom grade optical fiber can be used, eliminating the need for expensive and difficult-to-manufacture specialty fibers.

This article was written by Brian Soller, Ph.D, Strategic Business Development; Daniel Peairs, Senior Research Engineer; Alex Sang, Project Research Engineer; Luna Innovations (Roanoke, VA); and Antonio Fernandez, Department of Aeronautics, Universidad Politecnica de Madrid (Madrid, Spain). For more information, contact Dr. Soller at This email address is being protected from spambots. You need JavaScript enabled to view it., or visit http://info.hotims.com/28052-201.

White Papers

Working With Mechanical Motion Subsystems
Sponsored by Bell Everman
Telemedicine Robots Bring Expertise to Remote Areas
Sponsored by MICROMO
Reverse Engineering
Sponsored by Servometer
Improving Cable Performance in Harsh Environments
Sponsored by Gore
Expanding GNSS Testing with Multiple Synchronized Signal Recorders
Sponsored by Averna
3D Printing in Space: The Next Frontier
Sponsored by Stratasys

White Papers Sponsored By: