2011

Stainless Steel Surface Treatment

A treatment for stainless steel must impart high-release properties on par with non-stick coatings. The method should modify the surface of the stainless steel, but not reduce any of its existing properties, such as abrasion resistance, chemical resistance, or durability. The surface modification must resist sodium hydroxide and bleach (up to 180 °F), alkaline, and acidic staining. The non-stick properties should also offer super-hydrophobic features at a contact angle of 90 degrees or better.

Respond to this TechNeed at:
www.techbriefs.com/tn/201110c.html
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Phone: 781-972-0600


White Papers

10 Ways to Make Your Wiring and Harness Design Faster and Better
Sponsored by Mentor Graphics
When Wire Feedthroughs Make Sense
Sponsored by Douglas Electrical Components
Is There an Easy Way to Cut the Cost of EWIS Compliance?
Sponsored by Mentor Graphics
An Introduction to LED Capabilities
Sponsored by Photo Research
Electrical and Mechanical Integration in Aerospace Design
Sponsored by Mentor Graphics
Simulation of the ballistic perforation of aluminum plates with Abaqus/Explicit
Sponsored by Simulia

White Papers Sponsored By: