2011

Structural Detection of Welded Steel Regions

A non-destructive test mechanism is needed to detect fracture toughness, hardness, and microstructure properties of 1/8" steel weld zones. The device must measure the characteristics of flash upset welding of steel. In addition, the standalone technology should not function in a continuous, in-line manufacturing process. The detection system must also identify properties of a welded region, compare these results to both good and bad profiles, and alarm the operator of a specific failure type.


Respond to this TechNeed at:
www.techbriefs.com/tn/201111d.html
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Phone: 781-972-0600


White Papers

T&M Solutions for Software Defined Radios (SDR)
Sponsored by Rohde and Schwarz A and D
Step on It! Walking for Power
Sponsored by HP
How Lean Manufacturing Adds Value to PCB Production
Sponsored by Sunstone Circuits
The Basics Of Pressure Regulators
Sponsored by Beswick
Design Considerations to Meet the Urgent Demand for Miniaturization of Electronics in Military Applications
Sponsored by Fischer Connectors
Introduction to Hypervisor Technology
Sponsored by Curtiss-Wright Controls Embedded Computing

White Papers Sponsored By: