2012

Sterilizable Applicator for Pre-Mixed Liquid Formulation

An organization needs an inexpensive device to deliver a pre-measured amount of liquid evenly to a surface. The applicator is intended for a single use, must be able to be sterilized after final assembly, and needs to hold enough liquid or gel to cover about 1 to 3 square feet of surface completely. The user’s hands cannot touch either the liquid or the surface to which the liquid is being applied. The design should also be scalable so that units delivering as little as 3 mL can be manufactured.


Respond to this TechNeed at:
www.techbriefs.com/tn/201208c.html
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Phone: 781-972-0600

White Papers

The Significance of Critical Cleaning for Solar Module Fabrication
Sponsored by Alconox
Using Acoustic Beamforming for Pass-By Noise Source Detection
Sponsored by National Instruments
Guidelines for Ensuring PCB Manufacturability
Sponsored by Sunstone Circuits
10 Essential Questions for Reevaluating Your Medical Device Assembly Process
Sponsored by Nordson EFD
Changing Face of Robotics
Sponsored by Maplesoft
R&S® SMB100A, NRP, FSW-K6, ZVL Radar Educational Videos
Sponsored by Rohde and Schwarz A and D

White Papers Sponsored By: