2012

Nozzle Produces Ultrafine Droplets

Energy-saving nozzles offer droplet sizes down to 25 microns, at operating pressures as low as 100 psi. Nozzle passages, including metering slots, spin chambers, and exit orifices, are designed to minimize pressure drop, resulting in conservation of pump energy up to the exit orifice.

Macrolamination utilizes digital tooling for precise placement of critical geometries. The geometries are chemically machined into layers and provide smooth flow passages. Multiple flow circuits may reside on the same layer. The layers are then bonded together, forming a monolithic structure with the diffusion-welded joints approaching the parent material strength. Using only hydraulic pressure, Macrospray technology enables the production of very fine atomized sprays through a non-actuated nozzle.

Get the complete report on this technology at:
www.techbriefs.com/tow/201203b.html

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Phone: 781-972-0600

White Papers

Introduction to Hypervisor Technology
Sponsored by Curtiss-Wright Controls Embedded Computing
The Basics Of Pressure Regulators
Sponsored by Beswick
Avoid the High Cost of Quality Failure
Sponsored by Arena Solutions
How Lean Manufacturing Adds Value to PCB Production
Sponsored by Sunstone Circuits
Enhancing Ergonomics in Medical Equipment Design
Sponsored by Southco
Determining an Effective Analog Sampling Rate
Sponsored by Sealevel

White Papers Sponsored By: