About

An Introduction to Stress Analysis and Transducer Design Using Strain Gauges

Please Login at the top
of the page to download.

The usual way of assessing structural parts of machines, buildings, vehicles, aircraft, etc. is based on strength of material calculations.

This method is satisfactory provided the component loads are known both qualitatively and quantitively. Problems arise particularly where the loads are unknown or where they can only be roughly approximated. Formerly the risk of overloading was countered by using safety margins, i.e. through overdimensioning. However, modern design strategies demand savings in material, partly for reasons of cost and partly to save weight; this is clearly illustrated, for example in aeronautics. In order to satisfy the safety requirements and to provide an adequate component service life, the material stresses must be known. Therefore measurements under operational conditions are necessary.

White Papers

Spectrum Analyzer Fundamentals - Theory and Operation of Modern Spectrum Analyzers
Sponsored by Rohde and Schwarz A and D
Optimum Fastener Selection for Internal Pumping in Vacuum Systems
Sponsored by UC Components
IEC 61131-3 Now in Motion
Sponsored by Trio Motion
Avoid the High Cost of Quality Failure
Sponsored by Arena Solutions
The Ultimate Shaft-To-Hub Connection
Sponsored by Stoffel Polygon
Enhancing the Long-Term Reliability of Electronic Assemblies with Conformal Coatings
Sponsored by Master Bond

White Papers Sponsored By: