Special Coverage

Supercomputer Cooling System Uses Refrigerant to Replace Water
Computer Chips Calculate and Store in an Integrated Unit
Electron-to-Photon Communication for Quantum Computing
Mechanoresponsive Healing Polymers
Variable Permeability Magnetometer Systems and Methods for Aerospace Applications
Evaluation Standard for Robotic Research
Small Robot Has Outstanding Vertical Agility
Smart Optical Material Characterization System and Method
Lightweight, Flexible Thermal Protection System for Fire Protection
Home

These photodiodes have applications in LiDAR sensors, telecommunications links, and pulsed laser systems.

Traditional applications for 2-micron photodetectors have been largely dominated by passive remote sensing where detectors having bandwidth of even one megahertz are deemed sufficient. The onus in such applications is to achieve low dark current through active cooling. The advent of high-power, 2-micron-wave-length lasers have made coherent LiDARs viable for active sensing applications. Such a system needs photodetectors that can handle high local oscillator optical power and have large bandwidth. Through a combination of high coherent gain and small integration time, a large signal-to-noise ratio can be achieved. Operation at high optical power levels reduces the significance of photodiodes’ dark current. As a result, uncooled operation at room temperature is feasible, simplifying the overall instrument design.

Cross-section of the photodiode's epitaxial layer structure.

Lattice-mismatched, uncooled, 2.2-μm wavelength cutoff, InGaAs photodiodes and balanced photoreceivers with bandwidth up to 25 GHz were developed. The responsivity at 2.05 μm is 1.2 A/W, and the 1-dB compression, optical current handling of these photodiodes is 10 mA at 7V reverse bias. Such high-current-handling capacity allows these photodiodes to operate with a higher DC local oscillator (LO) power, allowing more coherent gain and shot-noise-limited operation. The impulse response of these devices shows rise time/fall time of ~15 ps, and full width half maximum of ~20 ps. These high-speed detectors can find utility in several 2-micron-wavelength applications including pulsed LiDARs, microwave photonics, and next-generation telecommunication links based on photonic bandgap fibers.

The epitaxial layer structure of the p-i-n photodiode is shown in the figure. The device was grown on a (100) oriented n-doped InP substrate. The growth sequence starts with an n-doped graded buffer layer of InAsyP1-y. The buffer layer is lattice-matched to InAs0.33P0.67 and InP at the top and bottom, respectively. The buffer layer contains compositionally abrupt interfaces that minimize the propagation of lattice defects into the active layers grown subsequently. As a result, the dark current and reliability of the photodiode are improved. An intrinsic In0.72Ga0.28As absorption layer is grown on top of the buffer layer.

Finally, an InAs0.33P0.67 contact layer is grown to provide the anode for the photodiodes. It is noteworthy that the lattice constant of the epitaxial layers increases along the growth direction. The resulting compressive strain prevents the epitaxial material from cracking. The photodiodes were fabricated using standard planar processing steps.

This work was done by Abhay Joshi of Discovery Semiconductors Inc. for Goddard Space Flight Center. NASA is seeking partners to further develop this technology through joint cooperative research and development. For more information about this technology and to explore opportunities, please contact Scott Leonardi at Robert. This email address is being protected from spambots. You need JavaScript enabled to view it.. GSC-16888-1

The U.S. Government does not endorse any commercial product, process, or activity identified on this web site.