Retaining Rings for Industrial Fastening Applications

Retaining rings are selected based on material, finish, and a variety of application parameters.

A discussion of retaining rings inevitably must begin with a debunking of myths; namely, that one style of retaining ring will function better than all other types in all instances. No one retaining ring style is better than another. Rather, the parameters of an application actually determine which retaining ring is best to use, and this can vary from assembly to assembly. Selecting the correct type of retaining ring based on variables such as installation/removal requirements, anticipated thrust load, and end-play take-up can ensure the retaining ring chosen will perform reliably, while significantly reducing fastener costs.

There are three main types of retaining rings available to the designer: tapered, constant section, and spiral. These typically are made from carbon steel, stainless steel, or beryllium copper, and feature a variety of finishes for corrosion protection. Again, the final selection of the type and size of retaining ring depends upon these and the previously mentioned parameters.

• Tapered Section Retaining Rings make uniform contact with the groove with a gap between the lugs. The lugs and lug holes are not meant to interfere with the application, but provide a convenient means to install/remove the ring using manual or automated equipment. Tapered rings are used in a variety of automotive applications, including ABS brakes and steering gears.
• Constant Section Retaining Rings are elliptical when installed in the groove, making only three-point contact. As a result, they accommodate less force than a tapered section ring, making them an economic alternative to this type of ring, depending on the application. They also offer more clearance than a tapered ring, but are more difficult to install/remove. Automotive transmissions are typical applications for constant section rings.
• Spiral Retaining Rings make 360° contact with the groove, unlike the other two types. However, they are difficult to install and remove and accommodate less force (on a ring-to-ring comparison). Typical applications include sprinkler valves, clutch drives, and quick-connect devices.
  
  «StartPrev12NextEnd»