Physical Sciences

Multipurpose Attitude and Pointing System (MAPS) Version 6.2

Lyndon B. Johnson Space Center, Houston, Texas MAPS is a suite of software tools used for pre-flight planning, real-time support, and post-flight analysis of spacecraft attitude and pointing for the International Space Station (ISS), HII Transfer Vehicle (HTV), Automated Transfer Vehicle (ATV), and other low Earth orbit (LEO) vehicles.

Posted in: Physical Sciences, Software, Briefs

Read More >>

Steady-State Thermal Test Methodology

This method allows the production of multiple test points from a single test. John F. Kennedy Space Center, Florida This innovation provides the following thermal properties data from a single steady-state test run: the effective thermal conductivity value (ke) for the full temperature difference, and multiple thermal conductivity values (λ) for intermediate temperatures. The test specimen (or material) is instrumented with one or more intermediate temperature sensors to allow the calculation of the multiple λ data points within the material and through its thickness. The methodology is particularly effective when coupled with any of the cryogenic boil-off calorimetry instruments (cryostats) developed by the Cryogenics Test Laboratory at NASA-KSC.

Posted in: Physical Sciences, Briefs, TSP

Read More >>

Silicon Carbide Power Processing Unit for Hall Effect Thrusters

Prototype achieved 96.5% peak efficiency. John H. Glenn Research Center, Cleveland, Ohio A high-efficiency, rad-hard, 3.5-kW SiC power supply was developed for the power processing unit (PPU) of Hall effect thrusters. This work specifically targets the design of a PPU power supply for the HiVHAC (High Voltage Hall Accelerator) thruster. The PPU power supply under development utilizes components that were irradiated under TID (total ionizing dose) conditions to greater than 3 Mrad with little to no change in device performance.

Posted in: Physical Sciences, Briefs, TSP

Read More >>

Intensity-Calibrated Hydrogen Flame Spectrum

Knowing the intensity spectrum of a hydrogen fire helps in evaluating fire detection methods. John F. Kennedy Space Center, Florida The National Aeronautics and Space Administration (NASA) uses large quantities of liquid hydrogen and has expended significant effort in the development, testing, installation, and maintenance of hydrogen fire detectors based on ultraviolet, near-infrared, mid-infrared, and/or far-infrared flame emission bands. Yet, prior to this work, there was no intensity-calibrated broadband hydrogen-air flame spectrum in the literature, making it difficult to compare the merits of different radiation-based hydrogen fire detectors.

Posted in: Physical Sciences, Briefs, TSP

Read More >>

Exciting and Detecting Electromagnetic Energy in a High-Temperature Microwave Cavity

This weak-coupling approach can be used by industry for temperature-dependent dielectric measurements of high-value materials. NASA’s Jet Propulsion Laboratory, Pasadena, California There is a need to perform accurate, high-temperature, complex dielectric constant measurements at microwave frequencies on materials, such as those on the surface of Venus (surface temperature 460 °C). One approach is to excite and detect a TE10n mode resonance in a waveguide cavity heated in a high-temperature furnace. The standard way is to use commercial high-temperature transition adapters attached to cavity end plates containing small iris holes that weakly couple microwave energy into and out of the cavity. These high-temperature transition adapters are not simple to make, and are rather large in size. The addition of the transition adapter units to the waveguide cavity leads to a long combined system that in many cases makes it difficult, if not impossible, to insert in conventional high-temperature furnaces.

Posted in: Physical Sciences, Briefs, TSP

Read More >>

Hollow aErothermal Ablation and Temperature (HEAT) Sensor for Tracking Isotherm Through TPS Material

This sensor can “see” through insulation. Ames Research Center, Moffett Field, California The Hollow aErothermal Ablation and Temperature (HEAT) sensor is a multifunction sensor designed to track an isotherm by making an independent transient measurement at a defined location in the sensor that is equal to the temperature at which its constituent materials char. By this same operating principle, the HEAT sensor tracks the transient char depth progression within a thermal protection system (TPS) material. In the case of a material that sublimes (such as Teflon), or when the aerothermal environment induces steady-state ablation, the HEAT sensor measures material ablation directly.

Posted in: Physical Sciences, Briefs, TSP

Read More >>

Hydrogen Measurement in a Cryogen Flow Stream Reduces Waste of Helium

Energy conservation and sustainability technologies are applied for propellant conservation. Stennis Space Center, Mississippi The purpose of this research was to develop an improved method for measuring hydrogen concentrations in a cryogen flow stream to minimize helium waste during the purge process. Currently, this type of measurement is performed manually with a sniffer, and involves obtaining periodic measurements that are not accurate or repeatable and do not optimize the conservation of hydrogen. The goal of this project was to create an autonomous real-time method for continuously measuring hydrogen that potentially offers not only cost saving advantages by conserving expensive resources that are used for purging, but also for providing an additional safety mechanism to monitor hydrogen in a cryogenic flow stream.

Posted in: Physical Sciences, Briefs

Read More >>

White Papers

Aqueous Critical Cleaning: A White Paper
Sponsored by Alconox
Estimating the Effort and Cost of a DO-254 Program
Sponsored by Logic Circuit
High Reliability Flexible Circuits for the Medical Marketplace
Sponsored by Tech Etch
Designing Ring Projections for Hermetic Sealing
Sponsored by Miyachi Unitek
Introduction to Hypervisor Technology
Sponsored by Curtiss-Wright Controls Embedded Computing
Serial Fabrics Improve System Design
Sponsored by Pentek

White Papers Sponsored By: