Unique Method for Orifice Production

Please Login at the top
of the page to download.

To produce accurate, repeatable orifices, all the variables that might influence the Cd Value (Coefficient of Discharge) must be controlled during production. This includes the orifice hole length, edges, surface finishes, roundness and the elimination of all tool marks, burrs, ragged edges and irregularities. If any one of these areas is not perfectly managed, the orifice flow rates will vary from piece to piece thereby making it impossible to predict flow with any accuracy.

White Papers

Multi-channel, Multi-board Coherency for SWaP-Constrained SIGINT and EW
Sponsored by curtiss wright
Adhesives, Sealants & Coatings for the Aerospace Industry
Sponsored by master bond
Software Defined Radio Handbook
Sponsored by Pentek
Determining an Effective Analog Sampling Rate
Sponsored by Sealevel
Antenna Basics
Sponsored by rohde and schwarz a and d
Removing the Gap Between ECAD and MCAD Design
Sponsored by Mentor Graphics

White Papers Sponsored By: