High vacuum cryogenic environments can be augmented with lightweight thermal shielding.

In the polar regions of the Moon, some areas within craters are permanently shadowed from solar illumination and can drop to temperatures of 100 K or lower. These sites may serve as cold traps, capturing ice and other volatile compounds, possibly for eons. Interestingly, ice stored in these locations could potentially alter how lunar exploration is conducted. Within craters inside craters (double-shaded craters) that are shaded from thermal re-radiation and from solar illuminated regions, even colder regions should exist and, in many cases, temperatures in these regions never exceed 50 K. Working in these harsh environments with existing conventional systems, exploration or mining activities could be quite daunting and challenging. However, if the unique characteristics of these environments were exploited, the power, weight, and total mass that is required to be carried from the Earth to the Moon for lunar exploration and research would be substantially reduced.

A Single- and a Double-Shaded Crater are shown on the lunar surface. Inside a double-shaded region within a single shaded crater, a thermal radiation shield reduces the heat transfer from the surface.
In theory, by minimizing the heat transfer between an object and the lunar surface, temperatures near absolute zero can be produced. In a single or double-shaded crater, if the object was isolated from the variety of thermal sources and was allowed to radiatively cool to space, the achievable temperature would be limited by the 3 K cosmic background and the anomalous solar wind that can strike the object being cooled. Our analysis shows that under many circumstances, with some simple thermal radiation shielding, it is possible to establish environments with temperatures of several degrees Kelvin. Electrostatic or other approaches for shielding from the solar wind and other high energy particles would enable the object to come into close thermal equilibrium with thermal cosmic background radiation. To minimize the heat transfer (conduction and radiation) between the ground and an object on the Moon (where the gravity is relatively small), a simple method to isolate even a relatively large object would be to use a low thermal insulating suspension structure that would hold both the thermal shield and the object above the thermal shield. The figure depicts a lunar polar region revealing a permanently shaded crater and a double-shaded crater. Within the double-shaded crater, a suspended thermal shield reflecting 50 K gray body radiation back towards the lunar surface, is shown. Extremely low heat conduction between the object and the lunar surface could also be produced by using superconducting magnetic levitation, such as the Meissner Effect, to support the thermal shield and object. The thermal radiation shield should be shaped so that it blocks the lunar surface thermal radiation from all directions.

Advanced thermal management architecture based upon the augmentation of thermal conditions in these craters would be able to support a wide variety of cryogenically based applications. Lunar exploration and habitation capabilities would significantly benefit if permanently shaded craters, augmented with thermal shielding, were used to permit the operation of near-absolute-zero instruments, including an array of cryogenically based propulsion, energy, communication, sensing, and computing devices. For example, many gases used for life support or propulsion systems could be stored as solids, eliminating or minimizing the need for storage vessels. Storage of cryogens and other volatiles in solid form could substantially reduce the mass that would have to be launched from the Earth to the Moon. Additionally, the ability to condense gases could serve as a means to purify air for breathing and other purposes.

Other uses for ultra-low temperature lunar craters (enhanced with artificial thermal radiation shielding) include the storage of biological samples, energy storage, advanced sensors, and even high-energy lasers for power transmission purposes. Since superconductors can theoretically store currents for billions of years, superconducting toroids serving as Superconducting Magnetic Energy Storage Systems could limitlessly store electrical energy from solar panels or other sources. Superconducting magnets could support a variety of applications, such as superconducting flywheel energy storage, drills, rail guns, and motors for vehicles. When cooled, semiconductor lasers can approach 100 percent wall-plug efficiency and could be used for transmitting power from one location to another. This technology could be used to beam power or information to land rovers and other mobile exploratory vehicles. Superconducting computers operating near terahertz clock speeds could potentially enable the development of consolidated, compact, high-end lunar-based computing devices.

« Start Prev 1 2 Next End»

The U.S. Government does not endorse any commercial product, process, or activity identified on this web site.