For the first time, researchers have shown that an optical fiber as thin as a human hair can be used to create microscopic structures with laser-based 3D printing. The innovative approach might one day be used with an endoscope to fabricate tiny biocompatible structures directly into tissue inside the body. This capability could enable new ways to repair tissue damage.
"With further development, our technique could enable endoscopic microfabrication tools that would be valuable during surgery," said research team leader Paul Delrot from École Polytechnique Fédérale de Lausanne, Switzerland. "These tools could be used to print micro- or nano-scale 3D structures that facilitate the adhesion and growth of cells to create engineered tissue that restores damaged tissues."
This new approach can create microstructures with a 1.0-micron lateral (side-to-side) and 21.5-micron axial (depth) printing resolution. Although these microstructures were created on a microscope slide, the approach could be useful for studying how cells interact with various microstructures in animal models, which would help pave the way for endoscopic printing in people.
To create the microstructures, the researchers dipped the end of an optical fiber into a liquid known as photopolymer that solidifies, or cures, when illuminated with a specific color of light. They used the optical fiber to deliver and digitally focus laser light, point by point, into the liquid to build a three-dimensional microstructure.
By printing delicate details onto large parts, the new ultra-compact microfabrication tool could also be a useful add-on to today's commercially available 3D printers that are used for everything from rapid prototyping to making personalized medical devices.
Current laser-based microfabrication techniques rely on a non-linear optical phenomenon called two-photon photopolymerization to selectively cure a volume deep inside a liquid photosensitive material. These techniques are difficult to use for biomedical applications because two-photon photopolymerization requires complex and expensive lasers that emit very short pulses as well as bulky optical systems to deliver the light.
To selectively cure a specific volume of material, the researchers took advantage of a chemical phenomenon in which solidification only occurs above a certain threshold in light intensity. By performing a detailed study of the light scanning parameters and the photopolymer's behavior, the researchers discovered the best parameters for using this chemical phenomenon to print microstructures using a low-power, inexpensive laser that emits continuously (rather than pulsed).
To create hollow and solid microstructures, the researchers used an organic polymer precursor doped with photoinitiator made of off-the-shelf chemical components. They focused a continuous-wave laser emitting light at 488-nanometer wavelength – visible-wavelength light that is potentially safe for cells – through an optical fiber small enough to fit in a syringe. Using an approach known as wavefront shaping they were able to focus the light inside the photopolymer so only a small 3D point was cured. Performing a calibration step prior to microfabrication allowed them to digitally focus and scan laser light through the ultra-thin optical fiber without moving the fiber.
"Compared to two-photon photopolymerization state-of-the-art systems, our device has a coarser printing resolution; however, it is potentially sufficient to study cellular interactions and does not require bulky optical systems nor expensive pulsed lasers," said Delrot. "Since our approach doesn't require complex optical components, it could be adapted to use with current endoscopic systems."