The design and initial demonstration of a laser pump module (LPM) incorporating single-mode, grating-stabilized 808- nm diode lasers and a low-loss, high-port-count optical combiner are completed. The purpose of the developed LPM is to reliably pump an Nd:YAG crystal in the laser head (LH), which serves as the optical metrology source for SIM-Lite mission. Using the narrow-linewidth, single-mode laser diodes enables placement of the pump power near Nd adsorption peak, which enhances pumping efficiency. Grating stabilization allows for stable pump spectra as diode operating temperature and bias current change. The low-loss, high-port-count optical combiner enables efficient combining of tens of pumps. Overall, the module supports 5+ years of continuous operation at 2 W of pump power with reliability approaching 100 percent.
The LPM consists of a laser diode farm (LDF) and a pump beam combiner (PBC). An array of 807- to 808-nm fiber-pigtailed laser diodes makes up the LDF. A Bragg grating in each 5-μm core single-mode (SM) fiber pigtail acts to stabilize the lasing spectra over a range of diode operating conditions. These commercially available single-mode laser diodes can deliver up to 150 mW of optical power. The outputs from the multiple pumps in the LDF are routed to the PBC, which is a 37-input by 1-output all-fiber device. The input ports consist of 5-μm core SM fiber, while the output port consists of 105- μm core, 0.15 NA (numerical aperture) multi-mode (MM) fiber. The combiner is fabricated by fusing the 37 input fibers while simultaneously tapering the fused region. At the completion of this process, the MM fiber is spliced to the end of the adiabatic taper, and, for protection, the combiner is sheathed by a capillary tube. A compact and robust metal housing was designed and fabricated to protect the PBC during space deployment.
Finally, the combined pump light is delivered to the LH via MM optical fiber. Within the head, the pump beam optical train matches the pump beam to the lasing mode profile, which enhances pumping efficiency. The LH houses non-planar resonant oscillator (NPRO), and provides all conditioning necessary for proper NPRO operation. Two large magnets ensure unidirectional propagation through the ring, mitigating hole burning. A set of heaters enables slow NPRO frequency tuning, while a piezoelectric transducer enables fast tuning. LH produces 300 mW at 1,319 nm when pumped by 1.9 W at 808 nm.
A software package predicting LDF reliability during the mission lifetime was developed based on the reliability theory of diode lasers. Extensive numerical simulations were carried out to select LDF architecture that meets the stringent reliability requirement (>99.7% probability of successful operation over 5.5 years), while balancing the competing needs to keep the number of laser diodes manageable and their operating temperature as close to room temperature as possible. Detailed sensitivity studies were also performed to make sure that the selected architecture is not vulnerable to possible deviations of key diode and mission parameters from their assumed values. The LDF architecture that was ultimately chosen meets the reliability requirements with 37 pump laser diodes operating at –1 °C (or –5 °C for an extra margin of safety).
This work was done by Hernan Erlig, Yueming Qiu, Ilya Y. Poberezhskiy, Patrick L. Meras, Daniel H. Chang, and Yen-Hung Wu of Caltech for NASA’s Jet Propulsion Laboratory. For more information, contact