A design concept for a beam for a specific application permits variations and options for satisfying competing requirements to minimize certain deflections under load and to minimize the weight of the beam. In the specific application, the beam is required to serve as a motion-controlled structure for supporting a mirror for optical testing in the lower third portion of a horizontal, cylindrical vacuum chamber. The cylindrical shape of the chamber is fortuitous in that it can be (and is) utilized as an essential element of the deflection-minimizing design concept.
By taking the standard beam-deflection equations, combining them with the geometric relationships among the legs and the horizontal portion of the beam, and treating the sliding as a component of deflection, it is possible to write an equation for the net vertical deflection as a function of the load and of position along the beam:
Total Deflection = (Deflection From Simple Support, Moment Load) + (Deflection From Simple Support, Twin Loads) + (Sliding at Wall)
The following is a summary of major conclusions drawn from the verbal characterization:
- The deflection at the point of application of a load cannot be made zero but it can be reduced, relative to the case of a simply supported beam of equal length.
- It is possible to obtain zero deflection at either the ends of the beam, the midlength point, or two points equidistant from the midlength point.
- The locations of the zero-deflection points are independent of the magnitude of the applied load. Moreover, if the beam and the legs are made of the same material and their cross sections are of the same size and shape, then the locations of the zero-deflection points are independent of the material and the cross sections.
- The maximum stresses occur at the ends of the horizontal portion of the beam.
Yet another advantage of the design concept arises from a fundamental geometric property. Just as a table having three legs of possibly unequal length can always rest on a horizontal surface without wobbling, a table having four legs of possibly unequal length can always rest on a cylindrical surface without wobbling. Hence, one can always be assured of realizing the desired geometry of contact between the beam and the cylindrical wall, and tolerances on leg lengths can be large. Hence, further, the cost of fabrication can be less than it would be if it were necessary to adhere to tight tolerances to ensure the desired geometry of contact.
This work was done by Dwight Goodman, Neill Myers, and Kenneth Herren of Marshall Space Flight Center. For further information, contact Sammy Nabors, MSFC Commercialization Assistance Lead, at