Experimental photonic switches developed at UC Berkeley have shown promise toward the goal of fully optical, high-capacity switching for future high-speed data transmission networks. The switch developed and tested for this research demonstrated capabilities not seen before in photonic switches. Key to this success, is the scale-up of a 240 × 240 integrated silicon photonic switch. The device is so-named because it accepts 240 optical communication input channels and sends them into 240 output channels.
The telecommunications industry long ago embraced fiber-optic technology as a better solution to meet exploding demand for higher speeds and greater capacity data transmission than could be achieved with copper wires. Now a similar revolution is occurring at the points where the messages transmitted over long-haul fibers are sent and received. Instead of power-hungry electrical switches that require optical-electrical-optical conversions and cause signal loss, researchers are developing and deploying photonic switches to improve transmission quality and link a single transmission to tens and sometimes thousands of servers.
Silicon-based photonic switches using advanced complementary metal-oxide semiconductor (CMOS) technology are drawing attention from researchers as a powerful platform due to their low cost and high capacity. They have the potential to replace electrical switches, which will soon face scalability limits in performance and energy efficiency. In order to realize this potential, researchers are now working to overcome limitations related to the size of today's silicon photonic chips and improve their performance. Up to now, the physical size of a silicon photonic chip has been limited to 2 to 3 cm because of the limitations of the lithography tools necessary to etch the required geometric patterns on the silicon wafers used as a base for the integrated chips. The researchers overcame this limitation by using a process known as lithography stitching, creating a wafer-scale 240 × 240 silicon photonic switch by stitching together nine 80 × 80 switch blocks in a 3 × 3 array, with three input and three output coupler blocks. The switches developed as part of the experiment coupled light coming in and out of the chip through grating couplers. The switch cells were actuated by electrical probes. The resulting switch area was 4 cm × 4 cm — nearly doubling the size of existing silicon photonic switches.
According to the researchers, the on-chip loss to port-count ratio (0.04 dB/port) is the lowest so far demonstrated. They went on to say that this technology can be applied not only to silicon photonic switches but also to any silicon photonics applications that require ultra-large-scale devices such as programmable photonic processors.
For more information, contact Leah Wilkinson at