Communication at higher frequencies is a perpetually sought-after goal in electronics because of the greater data rates that would be possible and to take advantage of underutilized portions of the electromagnetic spectrum. Many applications beyond 5G — as well as the IEEE802.15.3d standard for wireless communications — call for transmitters and receivers capable of operating close to or above 300 GHz.
Unfortunately, CMOS technology is not entirely suitable for such elevated frequencies. Near 300 GHz, amplification becomes considerably difficult. Although a few CMOS-based transceivers for 300 GHz have been proposed, they either lack enough output power, can only operate in direct line-of-sight conditions, or require a large circuit area to be implemented.
To address these issues, researchers have developed a design for a 300-GHz CMOS-based transceiver. One of the key features of the design is that it is bidirectional; a great portion of the circuit — including the mixer, antennas, and local oscillator — is shared between the receiver and the transmitter. This means the overall circuit complexity and the total circuit area required are much lower than in unidirectional implementations.
Another important aspect is the use of four antennas in a phased array configuration. Existing solutions for 300-GHz CMOS transmitters use a single radiating element, which limits the antenna gain and the system’s output power. An additional advantage is the beamforming capability of phased arrays, which allows the device to adjust the relative phases of the antenna signals to create a combined radiation pattern with custom directionality. The antennas used are stacked Vivaldi antennas, which can be etched directly onto PCBs, making them easy to fabricate.
The proposed transceiver uses a sub-harmonic mixer, which is compatible with a bidirectional operation and requires a local oscillator with a comparatively lower frequency; however, this type of mixing results in low output power, which led the team to resort to an old yet functional technique to boost it: out-phasing. This is a method generally used to improve the efficiency of power amplifiers by enabling their operation at output powers close to the point where they no longer behave linearly; that is, without distortion. Outphasing was used to increase the transmitted output power by operating the mixers at their saturated output power.
Another notable feature of the new transceiver is its excellent cancellation of local oscillator feedthrough (a “leakage” from the local oscillator through the mixer and onto the output) and image frequency (a common type of interference for the method of reception used).
The entire transceiver was implemented in an area as small as 4.17 mm2. It achieved maximum rates of 26 Gbaud for transmission and 18 Gbaud for reception — better than many of the state-of-the-art solutions.