Smaller (volume, mass, power) electronics for a Ka-band (36 GHz) radar interferometer were required. To reduce size and achieve better control over RF-phase versus temperature, fully hybrid electronics were developed for the RF portion of the radar’s two-channel receiver and single-channel transmitter. In this context, fully hybrid means that every active RF device was an open die, and all passives were directly attached to the subcarrier. Attachments were made using wire and ribbon bonding. In this way, every component, even small passives, was selected for the fabrication of the two radar receivers, and the devices were mounted relative to each other in order to make complementary components isothermal and to isolate other components from potential temperature gradients. This is critical for developing receivers that can track each other’s phase over temperature, which is a key mission driver for obtaining ocean surface height.

The fully integrated Ka-Band Dual-Channel Radar with horn antenna. The transmitter electronics are shown along the baseplate, while the dual receivers are mounted on the vertical plate. The last stage of the transmitter is left open to show the subcarriers.
Fully hybrid, Ka-band (36 GHz) radar transmitter and dual-channel receiver were developed for spaceborne radar interferometry. The fully hybrid fabrication enables control over every aspect of the component selection, placement, and connection. Since the two receiver channels must track each other to better than 100 millidegrees of RF phase over several minutes, the hardware in the two receivers must be “identical,” routed the same (same line lengths), and as isothermal as possible. This level of design freedom is not possible with packaged components, which include many internal passive, unknown internal connection lengths/types, and often a single orientation of inputs and outputs.

The last item is key to fabricating a dual-channel receiver, where one wants components from the two channels to be isothermal, and therefore mounted back-to-back, while also having the routing as similar as possible. This drives the design to be mirrored, where the two channels are fabricated back-to-back, achieving direct mechanical interface to improve the isothermal performance, which drives RF phase balance. This back-to-back design forces components to have a “left” and “right” handed version, which is not typically possible for packaged components, but with full design control of hybrid design, this is achievable. The radar was designed to have a series of separate subcarriers, which could be hermetically sealed individually, which is much easier than sealing the entire unit. Also, in the event of late component failure, rather than losing or reworking the entire unit, the subcarrier can easily be replaced by another qualified subcarrier.

This new instrument is a smaller, higher-bandwidth dual-channel interferometer with 500-MHz bandwidth at Ka-band (35.5 to 36 GHz), as compared to the prior instrument WSOA (Wide Swath Ocean Altimeter), which was Ku-band (13.275 GHz) with 80-MHz bandwidth. The new instrument has six-fold improvement in resolution capability, and better control of factors that contribute to RF phase stability.

This work was done by James P. Hoffman, Alina Moussessian, Masud Jenabi, and Brian Custodero of Caltech for NASA’s Jet Propulsion Laboratory. NPO-47346

This Brief includes a Technical Support Package (TSP).
Miniaturized Ka-Band Dual-Channel Radar

(reference NPO-47346) is currently available for download from the TSP library.

Don't have an account? Sign up here.