Soft robots and biomedical implants that reconfigure themselves upon demand are closer to reality with a new way to print shapeshifting materials. Researchers have developed a method to print objects that can be manipulated to take on alternate forms when exposed to changes in temperature, electric current, or stress.

The researchers first reported their ability to make morphing structures in a mold in 2018. But using the same chemistry for 3D printing limited structures to shapes that sat in the same plane. That meant no bumps or other complex curvatures could be programmed as the alternate shape. Overcoming that limitation to decouple the printing process from shaping is a significant step toward more useful materials.

These materials, once fabricated, will change shape autonomously, so the team needed a method to control and define this shape change. The new method uses multiple reactions in sequence to print the material and then dictate how it would change shape. Rather than trying to do this all in one step, the approach gives more flexibility in controlling the initial and final shapes and also allows printing of complex structures.

The lab’s challenge was to create a liquid crystal polymer “ink” that incorporates mutually exclusive sets of chemical links between molecules. One establishes the original printed shape and the other can be set by physically manipulating the printed and dried material. Curing the alternate form under ultraviolet light locks in those links. Once the two programmed forms are set, the material can then morph back and forth when, for instance, it’s heated or cooled.

The researchers had to find a polymer mix that could be printed in a catalyst bath and still hold its original programmed shape. Parameters such as the solvents and catalyst used, degree of swelling, and ink formula had to be optimized to allow the ink to solidify rapidly enough to print while not inhibiting the desired final shape actuation.

One remaining limitation of the process is the ability to print unsupported structures, like columns. To do so would require a solution that gels just enough to support itself during printing. Gaining that ability will allow researchers to print far more complex combinations of shapes.

Future work will further optimize the printing formula and use scaffold-assisted printing techniques to create actuators that transition between two different complex shapes, opening the door to printing soft robotics that could swim like a jellyfish, jump like a cricket, or transport liquids.

Watch the process in action on Tech Briefs TV here. For more information, contact Mike Williams at This email address is being protected from spambots. You need JavaScript enabled to view it.; 713-348-6728.