An alternative design for dielectric optical microresonators and a relatively simple process to fabricate them have been proposed. The proposed microresonators would exploit the same basic physical phenomena as those of microtorus optical resonators and of the microsphere optical resonators described in several prior NASA Tech Briefs articles. The resonances in such devices are associated with the propagation of electromagnetic waves along circumferential.paths in "whispering-gallery" modes. The main advantage afforded by the proposal is that the design and the fabrication process are expected to be amenable to production of multiple microresonators having reproducible spectral parameters — including, most notably, high values of the resonance quality factor (Q) and reproducible resonance frequencies.

High-Q optical microresonators are key components in many contemplated advanced optoelectronic applications, including high-stability, narrow-line-width microlasers; spectrometers; remote-sensing systems; memory devices; and optical delay lines. In all such applications, there are requirements for stable and repeatable spectra that contain the resonance spectral lines of interest and do not contain unwanted lines: in other words, there are requirements for microresonators that exhibit high Q with reproducible sparse spectra. Although prior microsphere and microtorus optical resonators have been shown to have the potential to satisfy these requirements, the techniques used heretofore to fabricate them, involving melting individual resonators under manual control, do not yield reproducible spectral parameters and, therefore, are not suitable for production of multiple, functionally identical units.

The figure depicts a microresonator and the fabrication thereof according to the proposal. In preparation for fabrication of a batch of microresonators, one would choose a silica tube of precisely calibrated diameter (typically about 6 mm), so that all the resonators in the batch could be relied upon to have the same diameter. One would cut the tube into shorter segments — one for each resonator. By use of a diamond cutter, a circumferential V groove would be made on the outer surface of each segment. By polishing with a diamond disk, all the material would be removed from one end of the segment (the lower end in the figure), up to the edge of the groove. Thus, what would remain at the polished end of the tube would be a quasi-toroidal resonator structure having a conical outer surface.

The edge region would be fire-polished by use of a hydrogen/oxygen torch to eliminate the roughness of the cut edge and conical surface and the residual roughness of the mechanically polished end face of the tube segment. This smoothing of the surface would reduce the loss of light propagating in whispering-gallery modes, thereby helping to ensure high Q (anticipated to be 109). The fire polishing would also round the edge slightly, but the radius of curvature of the edge would be small enough that the spectrum would remain sparse.

This work was done by Anatoliy Savchenkov, Vladimir Iltchenko, Lute Maleki, and Dimitri Kossakovski of Caltech for NASA's Jet Propulsion Laboratory. For further information, access the Technical Support Package (TSP) free on-line at www.techbriefs.com/tsp under the Physical Sciences category.

In accordance with Public Law 96-517, the contractor has elected to retain title to this invention. Inquiries concerning rights for its commercial use should be addressed to:

Innovative Technology Assets Management

JPL

Mail Stop 202-233

4800 Oak Grove Drive

Pasadena, CA 91109-8099

(818) 354-2240

E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Refer to NPO-30588, volume and number of this NASA Tech Briefs issue, and the page number.



This Brief includes a Technical Support Package (TSP).
Document cover
Manufacture of Sparse-Spectrum Optical Microresonators

(reference NPO-30588) is currently available for download from the TSP library.

Don't have an account? Sign up here.