Automotive Relays

CIT Relay & Switch, Minneapolis, MN, is offering an automotive relay with a blow-out magnet, specifically intended for the higher voltage switching required by electric vehicles. The A2K Series uses the blow-out magnet to help break the electric arc formed when the contacts of the relay are opening. Switching capacity is up to 60 amps, with resistor and diode options for coil suppression.

For Free Info Visit Here 


Power Inductors

The XGL1060 ultra-low loss power inductors from Coilcraft, Cary, IL, range from 1.0 to 10 μH, have up to 30 percent lower DCR than previous generation products, Isat ratings up to 48 A with soft saturation, AEC-Q200 Grade 1 qualified (–40 °C to +125 °C), and are a drop-in upgrade from the XAL1060 Series, with no thermal aging issue.

For Free Info Visit Here 


3-Phase EMC Filter

Schurter, Santa Rosa, CA, has expanded the FMAC NEO and FMAD NEO 3-phase filter families to meet all the safety features in IEC 60204-1. The filters have a short discharge time of the capacitors so that they have a touchable residual voltage of less than 60 V in 1 or 2 seconds after disconnecting the voltage. Any AC socket on the machine is RCD protected 30 mA for human protection.

For Free Info Visit Here 


RFID Read/Write Modules

AutomationDirect, Cumming, GA, has added RFID (Radio Frequency Identification) Read/Write modules from Con-trinex. They are available in 18 mm or 30 mm diameters and a 44 mm × 44 mm cube style with transmission ranges of up to 78 mm. These units can communicate to a PLC or other intelligent device using the popular IO-Link protocol.

For Free Info Visit Here 


Automotive Test Solution

Keysight, Santa Rosa CA, announced a new automotive serializer/deserializer (SerDes) receiver (Rx) compliance test solution to verify mobile industry processor interface (MIPI) A-PHY devices based on the Compliance Test Specification (CTS) requirements. This solution was developed in collaboration with BitifEye Digital Test Solutions GMBH and Wilder Technologies, with the support of Valens Semiconductor Ltd. (NYSE:VLN).

For Free Info Visit Here 


Panel Mount Connectors

Binder USA, Camarillo, CA, has expanded its M12 portfolio to include panel mount connectors with L-coding and dip solder contacts. The M12-L is a space-saving alternative to the 7/8-inch connectors typically used in power supplies, making it ideal for Industrial Ethernet applications in the PROFINET environment. When mated, the connector offers IP68-level protection, and is suitable for both front and rear panel mounting.

For Free Info Click Here 


3D Laser Scanning System

Optical Gaging Products (OGP®), Rochester, NY, has announced the addition of the ShapeGrabber Ai320 and the ShapeGrabber Ai820 to its family of automated 3D laser scanning systems. ShapeGrabber 3D Laser Scanning systems capture up to 1.5 million data points per second. The systems use a high-resolution scanhead for a wide variety of materials, colors, textures, and finishes.

For Free Info Click Here 


Dewatering Pumps

Sulzer, West Sussex, United Kingdom, has launched five new models of dewatering pumps for smaller tasks for drainage and sludge applications. Designated as ‘J’ for drainage and ‘JS’ for sludge, the new J4, J7, JS4, JS7, and JS8 models offer flowrates from 5.5 l/s with heads up to 16 m. Their slim design and low weight of construction makes them easy to transport between locations and set up for work.

For Free Info Click Here 


Position-Sensing Detector

Advanced Photonix, Camarillo, CA, is introducing a high-sensitivity, high-accuracy, 2-mm diameter position-sensing detector (PSD) with spectral response from the visible out to the near and shortwave infrared (NIR-SWIR) wavelengths. The APX-PSD-XVInG-3.1 is a low noise PSD with sensitivity from 400 nm to 1700 nm and high-position detection accuracy. They feature 2 kΩ inter-electrode resistance, high shunt resistance, low capacitance, and 20 μm position detection error.

For Free Info Click Here 


High-Speed Industrial Cameras

The uEye Warp10 from IDS Imaging Development Systems, Stoneham, MA, has 10 times the transmission bandwidth of 1GigE cameras and about twice the speed of cameras with USB 3.0 interfaces. With the 10GigE interface, this camera family is the fastest in the IDS range. The TFL mount, enables it to utilize the potential of large format (larger than 1.1") and high-resolution sensors (up to 45 MP).

For Free Info Click Here 


Multifunction Panel I/O System

United Electronic Industries (UEI), Norwood, MA, has released its new compact, rugged, and flexible Multifunction I/O solution designed to fit just about anywhere you need control and monitoring for your application. It can be installed in difficult-to-access locations, includes a small data acquisition (DAQ) and control solution, 40 analog and digital input/output channels, and it can handle industrial voltages up to 80 V.

For Free Info Click Here 


Signal and Spectrum Analyzers

Rohde & Schwarz, Columbia, MD, is introducing the new variants R&S FSV3050 and R&S FSVA3050 to its signal and spectrum analyzer family, now extended to 50 GHz. An additional option empowers the extension of signal analysis even up to 54 GHz. The high-speed analyzers for lab and production are ideal for 5G NR testing — now also supporting the full FR2 frequency range up to 52.6 GHz.

For Free Info Click Here 


Modular Position Switches

The recently developed ES/EM 97 series of position switches currently being launched by steute, Ridgefield, CT, have a modular design. The actuator heads can be easily fastened, replaced, or turned in 90-degree steps with four captive screws. They can be used in machine safety applications and achieve a safety level in line with Performance Level e to EN ISO 13849-1 and SIL 3 to EN 62061.

For Free Info Click Here 


Screw Terminal Capacitors

New Yorker Electronics, Northvale, NJ, has announced the release of Cornell Dubilier Electronics (CDE) DCMC Series of Aluminum Electrolytic Capacitors. Voltages range from 6.3 VDC to as high as 550 V rated (600 V surge) and capacitances ranging from 110 μF to 3,240,000 μF. They are designed to be used for power supply filters and energy storage applications such as welding equipment, UPS systems, and computer hold-up power.

For Free Info Click Here