Precise measurements utilizing sensitive instruments may require thermally managed detectors; therefore, thermal insulation of the detector is essential to its performance. To maintain critical signal-to-noise ratio, there is a need for larger thermal isolation structures. Due to high detector filling fraction limits, these isolation structures may be thinner, less mechanically robust, and more prone to breakage during fabrication.

This innovation is a process that fabricates thin dielectric membranes with high mechanical yields. These dielectric membranes may be perforated and include thermal isolation structures.

The process of forming a thermal insulation wafer begins with layering a photoresist pattern on an aluminum coated substrate. After the aluminum is etched, a temporary adhesive is applied to the photoresist and substrate. Next, the construction undergoes wafer scale bonding to a silicon insulator. The silicon insulator is then patterned and etched down to the buried oxide layer. The temporary adhesive is then dissolved in acetone. The acetone is diluted with non-polar solvents that are then removed via critical drying.

Multiple arrays of crystalline silicon membranes were produced that were 450-nm thick and were isolated from a silicon support structure by thermal isolation structures that were 30 microns thick and 5 microns long. The largest membranes, which had 100% mechanical yield, had an aerial footprint of 1.6 × 1.4 mm.

NASA is actively seeking licensees to commercialize this technology. Please contact NASA’s Licensing Concierge at This email address is being protected from spambots. You need JavaScript enabled to view it. or call us at 202-358-7432 to initiate licensing discussions. Follow this link here  for more information.

Tech Briefs Magazine

This article first appeared in the February, 2021 issue of Tech Briefs Magazine.

Read more articles from this issue here.

Read more articles from the archives here.