The cable industry uses cylindrical one-piece ducting, but installing cables in such a duct is labor-intensive, difficult, time-consuming, and expensive. This split-duct system features a patented extrusion manufactured from highimpact ABS plastic. The duct sections are hinged together along a longitudinal edge with an integral hinge and “snap” closing system. The system is placed in a trench in a “double-U” configuration and the cables are then laid into the duct. Once the cables are laid, the other half of the ducting system snaps into place, locking the two halves firmly together.

The ducting system can also be placed above ground or in ceilings, and comes in a standard length of 3 meters, including bends, tees, and offset sections.

Get the complete report on this technology at:

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.

Phone: 781-972-0600