A report describes the personal radiation protection system (PRPS), which has been invented for use on the International Space Station and other spacecraft. The PRPS comprises walls that can be erected inside spacecraft, where and when needed, to reduce the amount of radiation to which personnel are exposed. The basic structural modules of the PRPS are pairs of 1-in. (2.54-cm)-thick plates of high-density polyethylene equipped with fasteners. The plates of each module are assembled with a lap joint. The modules are denoted bricks. A report discusses the attitude-control system of a proposed spacecraft that would derive at least part of its propulsion from a solar sail. The spacecraft would include a bus module containing three or more reaction wheels, a boom attached at one end to the bus module and attached at its other end to a two-degree-of-freedom (DOF) gimbal at the nominal center of mass of a sail module. Each DOF of the gimbal could be independently locked against rotation or allowed to rotate freely. By using the reaction wheels to rotate the bus when at least one gimbal DOF was in the free state, the center of mass (CM) of the spacecraft could be shifted relative to the center of pressure (CP) on the solar sail. The resulting offset between the CM and CP would result in a solar torque, which could be used to change the attitude of the spacecraft. The report discusses numerous aspects of the dynamics and kinematics of the spacecraft, along with the relationships between these aspects and the designs of such attitude-control-system components as sensors, motors, brakes, clutches, and gimbals.
This work was done by Edward Mettler and Scott Ploen of Caltech for NASA's Jet Propulsion Laboratory. For further information, access the Technical Support Package (TSP) free on-line at www.techbriefs.com/tsp under the Machinery/Automation category. NPO-30522