The European Organization for Nuclear Research (CERN) requires new magnets that are smaller than their predecessors to accommodate new instrumentation. Because of their size, these magnets need to generate a 24 percent stronger magnetic field and the structure must provide for near-zero deformation of the conductor. Even a small deformation could increase the electrical resistance and raise the temperature enough to cause the conductor to lose its superconducting state. Engineers addressed this challenge using ANSYS electromagnetic, thermal, and structural simulation tools. Coupling the multiphysics domains in the ANSYS® Workbench® environment allowed the team to optimize the design by simultaneously considering all of the physics.

Engineers used ANSYS electromagnetic, thermal, and structural simulation tools coupled in the ANSYS Workbench environment to optimize the design of magnets for the Large Hadron Collider.
The Large Hadron Collider (LHC) is the world’s largest and most powerful particle accelerator. Inside the accelerator, two high-energy particle beams travel in opposite directions in separate beam pipes at close to the speed of light before being forced to collide. These beams are guided around the accelerator ring by a magnetic field maintained by superconducting electromagnets operating at 1.9 K (–271.3 °C). Upgrading the current layout of the LHC requires the installation of new, smaller magnets. Consequently, these smaller magnets must compensate by generating an 11 Tesla (T) magnetic field compared with the current 8.33T magnets. This requires a change in materials from niobium-titanium to triniobium-tin. While working at CERN, the author performed extensive analysis to design an 11T superconducting accelerator magnet.

The magnets must be extremely rigid, because even minute shifts of the conductor could initiate quenches (transition of the conductor from the superconducting to the resistive state). These new magnets generate axial forces that are almost double the existing main dipoles on the LHC. The old methodology for designing magnets was so time-consuming that only a few design alternatives could be considered, and it was not possible to simultaneously optimize the design based on its performance in multiple domains. Engineers introduced a new methodology for designing this next generation of superconducting magnets by combining advanced computer-aided design tools with coupled multiphysics simulation in an integrated design environment.

ANSYS Maxwell 3D electromagnetic analysis model.
The electromagnetic forces known as Lorentz forces were calculated by ANSYS Emag and ANSYS Maxwell®, and transferred to ANSYS Mechanical™ as body force densities. Engineers then conducted structural and thermal analyses, taking into account the higher rigidity of the structure after cooling to the operating temperature. The team explored the design space and determined the sensitivity of the design to the various parameters using ANSYS DesignXplorer. This tool automatically swept through hundreds of iterations and identified a design that minimized the use of expensive magnetic material while meeting the rigidity and size requirements, as well as the limitations of the manufacturing process.

Some subassemblies of the proposed optimized design have already been built and tested, and their performance matches the simulation predictions. The LHC is scheduled to re-open in 2015.

This article was written by Charilaos Kokkinos, Mechanical & Aeronautics Engineer, FEAC Engineering. Kokkinos left CERN in 2013 to found FEAC Engineering, a startup engineering company in Ioannina, Greece specializing in simulation-driven product development. FEAC warmly thanks Mikko Karppinen, the project leader of the 11T dipole magnet. For more information, visit  and .

Software Tech Briefs Magazine

This article first appeared in the September, 2014 issue of Software Tech Briefs Magazine.

Read more articles from this issue here.

Read more articles from the archives here.