Atomic Layer Deposition (ALD) is being used as a means of coating various substrate materials with a variety of metallic and ceramic oxides for corrosion and thermal protection. The technology necessary to develop a state-of-the-art,...

Innovators at NASA's Glenn Research Center have developed several new technological innovations to improve the capability of Hall-effect thrusters, which are used primarily on Earth-orbiting satellites and can also be used for deep-space robotic vehicles. Hall thrusters are susceptible to discharge channel...

Innovators at NASA's Glenn Research Center have developed a method for fabricating a fiber-reinforced diamond composite coating on the surfaces of sliding thrust bearings at low and cryogenic temperatures....

Innovators at NASA's Glenn Research Center have developed a number of materials and methods to optimize the performance of nanomaterials by making them tougher, more resistant, and easier to process. Glenn's scientists are generating critical improvements at all stages of...

The use of thin-film sensors has several advantages over wire or foil sensors. For example, thin-film sensors do not require special machining of the components on which they are mounted, and, with thicknesses less than 10 μm, they are considerably thinner than wires or...

The primary purpose of this work is to develop and demonstrate technologies to manufacture ultra-low-cost precision optical systems for very large x-ray, UV/optical, or infrared telescopes.

Bearing surfaces are typically either metal-on-metal (MOM), ceramic-on-ceramic (COC), or metal-on-polyethylene (MOP). MOM and MOP couplings have the drawback that metallic or polyethylene particles can sometimes separate from the couplings, which can cause significant problems, particularly in a hip or joint...

The Toughened Uni-piece Fibrous Reinforced Oxidation-Resistant Composite (TUFROC) allows for much more affordable and sustainable operations involving Space Launch Services and other systems that utilize Earth re-entry vehicles. TUFROC has an exposed surface design and...

Innovators at NASA’s Glenn Research Center have developed a method for producing pure high-pressure oxygen via an electrochemical pumping process through a solid oxide electrolysis (SOE) cell stack. Glenn’s device can either concentrate the...

The Toughened Uni-piece Fibrous Reinforced Oxidation-Resistant Com posite (TUFROC) allows for much more affordable and sustainable operations involving Space Launch Services and other systems that utilize Earth reentry vehicles. TUFROC has an exposed surface design and...

This project is focused on the development of a high-force, high-speed piezoelectric actuator for control of a 2-inch (≈5-cm) isolation valve application in a cryogenic vacuum environment. The piezo motor actuators on the two cryogenic isolation valves were successfully tested at...

A ceramic vacuum chuck is used to hold large detector arrays flat while being attached parallel to a rigid substrate. Once held in the vacuum chuck, the component is typically seized by epoxy against a rigid substrate. The problem that interferes with this operation happens when the epoxy...

This innovation provides for significantly improved protection from micrometeoroid and orbital debris (MMOD) particles, and reliably determines the location, depth, and extent of MMOD impact damage.