Materials

Researchers from the University of Southern Denmark have synthesized crystalline materials that can bind and store oxygen in high concentrations.The stored oxygen can be released again when and where it is needed.Depending on the atmospheric oxygen content, temperature, or pressure, it takes seconds,...

Liberation of oxygen from the mineral ilmenite (FeTiO3), which may be found on the Moon, Mars, or asteroids, is inefficient due to the abundance of other minerals in the excavated regolith that are present but not needed during the chemical processing....

In the process of recovery and regeneration of cabin atmosphere to supply oxygen to facilitate extended-duration manned missions, including expeditions to Mars or a return to the Moon, one of the byproducts of this reaction is waste methane, which is vented into space. This...

Future-generation materials for use on space transportation vehicles require substantial improvements in material properties, leading to increased reliability and safety, as well as intelligent design to allow for current materials to meet future needs. Ultra-high-temperature...

A highly reflective, white conductive coating system was developed using various layered coatings to maximize the structural, electrical, and optical reflectance properties for spacecraft radiators. The top layer of the system contains a highly reflective white pigment within a dissipative...

Ambient air insulation systems for low-temperature (sub-ambient) applications are difficult to achieve because of moisture ingress and environmental degradation, as well as thermal stress-cracking. Most currently accepted methods for externally applied outdoor environments are...

The current baseline ablator material for the Advanced Development Program (ADP) for the thermal protection system (TPS) of the Orion heat shield is phenolic impregnated carbon ablator (PICA). PICA is a low-density, low-strength material that must be isolated from mechanically and thermally induced deformations and strains of the...

Researchers are developing a robotic, sensor-embedded fabric that moves and contracts. Such an elastic technology could enable a new class of soft robots, stretchable garments, "g-suits" for pilots or astronauts to counteract acceleration effects, and lightweight, versatile robots to roam alien landscapes during...

The first 3D printer is soon to fly into Earth orbit, finding a home aboard the International Space Station (ISS). The size of a small microwave, the unit is called Portal. The hardware serves as a testbed for evaluating how well 3D printing and the microgravity of space combine. The soon-to-fly 3D...

Researchers at MIT and Northeastern University have equipped a robot with a novel tactile sensor that lets it grasp a USB cable draped freely over a hook and insert it into a USB port.The sensor is an adaptation of a technology called GelSight, which was developed by the lab of Edward Adelson, the...

Researchers from North Carolina State University have developed a technique for controlling the surface tension of liquid metals by applying very low voltages, opening the door to a new generation of reconfigurable electronic circuits, antennas and other technologies. The technique hinges on the...

The quest to create artificial "squid skin" — camouflaging metamaterials that can "see" colors and automatically blend into the background — is one step closer to reality, thanks to a color-display technology by Rice University's Laboratory for Nanophotonics (LANP).The new full-color display...

Developers from Harvard’s School of Engineering and Applied Sciences and the Wyss Institute for Biologically Inspired Engineering have produced the first untethered soft robot — a quadruped that can stand up and walk away from its designers. The researchers were able to scale up earlier soft-robot...

A team of researchers at Michigan State University has developed a new type of solar concentrator that when placed over a window creates solar energy.The device is called a transparent luminescent solar concentrator and can be used on buildings, cell phones, and any other device that has a clear...

The FAA, using its CARI-6 program, provides galactic cosmic radiation dosage rates for any location on the Earth from ground up to 60,000 ft (≈18,300 m). One way to protect astronauts from galactic cosmic radiation (GCR) on a Mars mission is to use...

Elementary-reaction chemical kinetics of hydrocarbon oxidation consists of hundreds to thousands of species and thousands of reactions. As such, it is impossible to use it in models and codes involving turbulence because computations are unfeasible due to lack of memory and...

A model describing supercritical-pressure, multi-species turbulent mixing has been developed to simulate situations prevailing in diesel, gas turbine, and HCCI (homogeneous charge compression ignition) engines. It is also a situation occurring in atmospheric planetary science,...

Copoly(alkyl ether imide)s were synthesized for the purposes of tailoring surface chemistry. Alkyl ether oligomers with amine end groups were synthesized from the hydroxyl-terminated species, and subsequently reacted with aromatic dianhydrides and diamines to make the...

Two methods have been developed for functionalizing carbon nanotubes in solvent-free conditions. In one method, purified single-walled carbon nanotubes (SWNTs) and a diazonium salt are added to a metal vial, which is loaded with a stainless steel ball bearing. The metal...

High-efficiency tantalum-based ceramic (HETC) composite structures are suitable for use in thermal protection systems. These composite structures have high-efficiency surfaces (low catalytic efficiency and high-emittance), thereby reducing heat flux to a spacecraft during planetary...

TUFROC has an exposed surface edge design and an appropriate materials combination for a space vehicle that will survive the mechanical stresses induced in the initial ascent, and will subsequently survive the extreme heating and mechanically stressful environment of...

Scientists at Stanford University have developed a low-cost, emissions-free device that uses an ordinary AAA battery to produce hydrogen by water electrolysis. The battery sends an electric current through two electrodes that split liquid water into hydrogen and oxygen gas. Unlike other water splitters that use...

Materials like solid gels and porous foams are used for padding and cushioning, but each has its own advantages and limitations.A team of engineers and scientists at Lawrence Livermore National Laboratory (LLNL) has found a way to design and fabricate, at the microscale, new cushioning materials with a...

A new class of electroactive polymeric blend materials has been created that offers both sensing and actuation dual functionality. The blend is comprised of two components where one has sensing capability, and the other has actuating capability. These innovative materials provide significant field-induced strain, high...