Power Management

New phase change material was developed that has electrical characteristics that behave differently than those of conventional materials. This new material provides a drastic reduction in power consumption for data recording in nonvolatile random access memory (RAM).

Traditional altitude switch designs for harsh environments are mechanical in nature and operate by means of an inflatable bladder or bellows that mechanically depresses a pushbutton switch. The altitude trip point is set by mechanically adjusting the distance of the switch to the bellows. The mechanical action of the...

Electrical interruptions, or “nuisance trips,” occur when a detector installed behind the wall trips an outlet's electrical circuit when it senses something that could be an arc-fault — a potentially dangerous spark in the electric line. The problem with today's arc-fault detectors is that they...

As the number of channels, or operative sites, increases in present and future ground special power (GSP) development efforts, the amount of hardware required to test development codes becomes substantially expensive. By simulating/emulating the hardware, code...

Metal alloys, such as titanium alloys and steels, are known to have a good combination of mechanical properties for many structural applications, but these metal alloys do not meet the wear and corrosion resistance requirements for some structural applications. Titanium alloys, for example,...

Some insect bodies have evolved the ability to repel water and oil, adhere to different surfaces, and eliminate light reflections. Scientists have been studying the physical mechanisms underlying these properties found in nature and mimicking them to design materials for use in everyday...

Supercapacitors are rechargeable energy storage devices that deliver more power for their size than similar-sized batteries. They also recharge quickly, and they last for hundreds to thousands of recharging cycles. Today, they are used in hybrid cars’ regenerative braking systems and for other...

Positioning of wireless devices is centralized, depending on “anchors” with known locations such as cell towers or GPS satellites to communicate directly with each device. As the number of devices increases, anchors must be installed at higher density. Centralized positioning can...