Plastics

Purdue University researchers have developed a technique to embed a liquid-alloy pattern inside a rubber-like polymer to form a network of sensors. The approach may be used to produce "soft machines" made of elastic materials and liquid metals.Such an elastic technology could be used to create robots with...

Scientists from Imperial College London have developed a 3D-printing Micro Aerial Vehicle (MAV) that mimics the way that swiftlets build their nests.The MAV is a quad-copter, with four blades that enable it to fly and hover. The vehicle, made from off-the-shelf components, carries in its underbelly two...

Illinois researchers have developed materials that not only heal, but regenerate. The restorative material is delivered through two, isolated fluid streams (dyed red and blue). The liquid immediately gels and later hardens, resulting in recovery of the entire damaged region. For regenerating...

An Iowa State research team led by Reza Montazami is developing "transient materials" and "transient electronics" that can quickly and completely melt away when a trigger is activated. The development could mean that one day you might be able to send out a signal to destroy a lost credit card.To...

A synthetic leather material delivers a durable touch-feel. The design is based on the way that the human fingertip interacts with surfaces along four different axes of material properties. The fingertip determines whether a surface is soft or hard, smooth or coarse, wet or dry, and warm or...

One day in 2010, a Rutgers physicist watched a store employee showcase a kitchen gadget that vacuum-seals food in plastic. The simple concept – an airtight seal around pieces of food – just might apply to his research: developing flexible electronics using lightweight organic semiconductors for...

This technology gives hard-surface plastics a soft and moist feel by imposing a “grain” or texturing onto the surface. It has application in automotive interiors, household utensils, electronics, mobile phones, and other locations where a hard plastic surface...

A report reopens the discussion of “Sequestration of Single-Walled Carbon Nanotubes in a Polymer” (MSC-23257), NASA Tech Briefs, Vol. 31, No. 12 (December 2007), page 38. To recapitulate: Sequestration of single-walled carbon nanotubes (SWNTs) in molecules of...

Functionalization of carbon nanotubes (CNTs) with linear molecular side chains of polyphenylene ether (PPE) has been shown to be effective in solubilizing the CNTs in the solvent components of solutions that are cast to make epoxy/CNT composite films. (In the absence of solubilization, the CNTs...

A method has been developed for improving heat flux performance relative to flat surfaces in spray-cooling systems. Similar enhancement techniques have been used for convective heat transfer, but, to the best knowledge at the time of this reporting, never spray cooling of...

Sequestration of single-walled carbon nanotubes (SWCNs) in a suitably chosen polymer is under investigation as a means of promoting the dissolution of the nanotubes into epoxies. The purpose of this investigation is to make it possible to utilize SWCNs as the reinforcing fibers in strong,...

University of Michigan researchers have created a composite plastic that's as strong as steel but lighter and transparent. The composite plastic is made of layers of clay nanosheets and a water-soluble, glue-like polymer. UM engineering professor Nicholas Kotov and others have solved a problem that has confounded engineers...