No CubeSat-compatible, Deep Space Network (DSN)-compatible communications and navigation transponder exists at the time of this reporting. In order for CubeSats and other small spacecraft to go into deep space, a DSN-compatible capability is needed.

Interest in the use of THz detectors outside the laboratory for space, atmospheric, and terrestrial applications has grown immensely in the past half-century. Of particular interest in recent years is the development of the quantum cascade laser (QCL) as a THz frequency source.

There is limited space available to install numerous avionics boxes with the caveat that each box is a line replacement unit (LRU). Access to enable the removal of the boxes is limited, and it is critical that no tools and/or loose parts exist to ensure that no damage is done to aft-located components....

There are two broad classes of methods for measuring skin friction (or wall shear): indirect and direct. The direct methods generally employ a movable element of the actual surface surrounded by a very small gap and connected to some type of flexure. One then measures the displacement of...

The I2C/SPI Verilog core consists of a combined register transfer logic (RTL) Verilog code for a general-purpose I2C and serial-to-parallel interface (SPI) slave for implementations targeting field programmable gate arrays (FPGAs) and application specific integrated circuits (ASICs)....

Electrical checkout and testing is a critical part of the overall space integration and test flow. Verifying proper harness and connector signal interfaces is key to ensuring component health and overall system functionality. Break-out boxes (BOBs) are used to give test...

The EXPRESS Logistics Carrier (ELC) system was built by NASA Goddard for installation on the International Space Station (ISS). Four ELC systems are on ISS. Each ELC site includes two data nodes. The ELC requirements call for a radiation-hardened 10BASE-T Ethernet interface at each data...

Cups/cones are being used to provide a shear load transfer capability on a large separation interface that uses multiple discreet retention and release (R&R) devices (such as frangible nuts, separation nuts, separation bolts, etc.). To both provide good...

Typical spacecraft thruster configurations are often unable to provide full six-degree-of-freedom control and may have unwanted interaction between their attitude control and trajectory control functions, have undesirably high instantaneous electrical power demands, and use more thrusters than...

A closed/semi-open pressure or vacuum system uses an electric screw mechanical actuator that can be digitally controlled and monitored, and which receives feedback directly from an external or internal source. This innovation can adjust for media temperature changes,...

To model high-pressure reactive flows, the most promising methodology is large eddy simulation (LES) in which one solves the large scales of the problem and models the small scales. There is currently no guidance as to the relative importance of small scales originating...

This project is focused on the development of a high-force, high-speed piezoelectric actuator for control of a 2-inch (≈5-cm) isolation valve application in a cryogenic vacuum environment. The piezo motor actuators on the two cryogenic isolation valves were successfully tested at NASA...

During the transportation of any sample material, it is important to ensure that no damage or contamination of the sample occurs while in transit. This concept is extremely important within the sample caching rover sample return architecture. Adequately sealing the sample tubes is important...

A ceramic vacuum chuck is used to hold large detector arrays flat while being attached parallel to a rigid substrate. Once held in the vacuum chuck, the component is typically seized by epoxy against a rigid substrate. The problem that interferes with this operation happens when the epoxy...