Magazine

Observations in modern datasets have a continuum of quality that can be hard to quantify. For example, satellite observations are subject to often-subtle mixtures of confounding forces that distort the observation’s utility to a varying extent. For the Orbiting Carbon Observatory-2 (OCO-2)...

Advanced Rapid Imaging and Analysis for Earthquakes (ARIA-EQ) will be the first coordinated effort to automate geodetic imaging capabilities so they can be used for hazard response. The innovation is an automatic geodetic imaging data system that is the foundation for an operational hazard...

The Propellant Feed System Analytical Tool (PFSAT) predicts heat leak based on insulation type, installation technique, line supports, penetrations, and instrumentation. It also determines the optimum orifice diameter for an optional thermodynamic vent system (TVS) to counteract heat leak into the...

Aradiation-hard, 130-Volt, 100-KHz capable, quad-channel operational amplifier with corresponding power supply and 6th-order Bessel filter circuitry has been designed, fabricated, and successfully tested. To control two-axis microelectromechanical systems (MEMS)-based mirrors, a differential...

Microwave interferometry provides a means of synthesizing large scanning antennas that are not otherwise physically practical for spaceborne Earth observational systems. By cross-correlating multiple receivers of an array, high-resolution images are synthesized from a sparse — or thinned — array of...

In this work, there were four independent vision modules implemented in an FPGA: a CameraLink camera interface, rectification, bilateral filtering, and stereo disparity correlation. Each module was originally designed to run from end to end, not in a pipeline with the other modules. This limited...

Cross-linked silica-based aerogels with polymeric materials, as well as incorporating a flexible linkage into the underlying metal oxide, have been proven to improve strength and resilience over their native, or non-cross-linked, counterparts without adversely affecting porosity and density. In...

An easy and instant method of detection was needed for AF-M315E, a “green” propellant that produces very little vapor. This makes it hard to detect by smell or other active sensors.

A method of forming a composite of embedded nanofibers in a polymer matrix with a high degree of alignment has been created using a nanofiber continuous fiber (NCF) system. This innovation incorporates nanofibers in a plastic matrix forming agglomerates, and then uniformly distributes them by...

Multi-element compounds have been used ubiquitously in various applications, including electronics, optics, opto-electronics, thermoelectrics, superconductivity, and the recently developed application of spintronics. Besides being the main components of some of...

A need arose for approximately 1 cm2 of a diamond-like-carbon (DLC) concentrator target for the analysis of solar wind nitrogen isotopes. The original target was a circular quadrant with a radius of 3.1 cm; however, the piece did not survive intact when the spacecraft suffered an...

High-aspect-ratio silicon structures are necessary components in many MEMS (microelectromechanical systems). Aspect ratio is defined as the ratio of the height of the structure to its lateral width. The structures are typically fabricated through bulk micromachining...

Existing aerospace flight trajectory programs simulate the motion of aerospace vehicles by modeling external forces and moments acting on each body, but lack provisions for determining reaction forces and moments exerted by one body on another through a...

The Space Station Integrated Kinetic Launcher for Orbital Payload Systems (SSIKLOPS), also known as “Cyclops,” deployed the largest satellite ever from the International Space Station (ISS) on November 28, 2014. The satellite, SpinSat, a Naval Research...

A vacuum-jacketed, cryogenic flex hose was designed with an integrated flange to be able to pass through a vacuum chamber wall. This design increases the quality of the cryogenic fluid at the exit of the hose (i.e., more liquid, less vapor) by extending the hose vacuum-jacket through the chamber wall, where...

Power consumption during all phases of spacecraft flight is of great interest to the aerospace community. As a result, significant analysis effort is exerted by both system and electrical-domain engineers to understand the rates of electrical energy generation and consumption under many...