Electrical/​Electronics

Microvolt-level signals require gains of at least a thousand. Offsets and noise in the amplifier chain will be amplified by the same amount, which can saturate the amplifier or swamp the signal so it is not resolvable. Other methods use chopping and/or autozero techniques to lower the offset and noise. The key...

Derived from a design approach for a new wing known as PRANDTL-D, this technology achieves similar improvements for propellers and other rotating machinery.

NASA Goddard Space Flight Center has developed a pointing measurement detection and control system that monitors the real-time optical axis motions (such as tip and tilt) that affect image quality in aerial platforms. To date, there is no known real-time optical image alignment and control...

Microelectromechanical systems (MEMS) filters have advantages in being able to reduce the size, weight, and power required when used as part of electronic systems such as radios; however, MEMS-type filters have limitations. For example, thickness MEMS-type filters (e.g., thickness-extensional mode...

A noise source is an enabling technology for passive millimeter-wave remote sensing applications such as atmospheric sounding, and precipitation and ice cloud measurements. NASA Goddard Space Flight Center has developed a packaged noise source that will allow calibration of the front end at the...

Electrical power lines pose a serious crash hazard to helicopters and other air-based vehicles, especially small aerial vehicles such as unmanned aircraft systems (UAS). This is because power lines are so widespread, hard to see, and strung at roughly the same height above the ground at...

The most dense solid-state memory ever created could soon exceed the capabilities of current computer storage devices by 1,000 times using a new technique. The same technology was used to manufacture atomic-scale circuits, allowing for quickly removing or replacing single hydrogen atoms. The technology...