Mechanical & Fluid Systems

In a structural cold plate, typically there is a structural member such as a honeycomb panel or a brazed sandwich assembly that provides the structural strength, and at least one cold plate that cools equipment attached to the structural member. The cold plate...

Typical aerospace rocket engines use valves to control the flow and pressures of propellant and pressurants. These typical valves are designed to operate with a mechanical, electromechanical, or pneumatic operator. They all have at least one, and often multiple, penetrations from...

AMars “sample caching rover” mission designed to collect, document, and package samples for future collection and return to Earth was recommended as the highest-priority mission for 2013–2022 by the 2011 Planetary Decadal Survey. A key premise of...

This software predicts flow through the initiator of a Primer Chamber Assembly Valve. These valves exhibited a potential failure mode for specific operating conditions where dual simultaneous firings of the initiator occurred. The software tool was able to identify a fluid dynamic...

Existing aerospace flight trajectory programs simulate the motion of aerospace vehicles by modeling external forces and moments acting on each body, but lack provisions for determining reaction forces and moments exerted by one body on another through a...

The Space Station Integrated Kinetic Launcher for Orbital Payload Systems (SSIKLOPS), also known as “Cyclops,” deployed the largest satellite ever from the International Space Station (ISS) on November 28, 2014. The satellite, SpinSat, a Naval Research...

A vacuum-jacketed, cryogenic flex hose was designed with an integrated flange to be able to pass through a vacuum chamber wall. This design increases the quality of the cryogenic fluid at the exit of the hose (i.e., more liquid, less vapor) by extending the hose vacuum-jacket through the chamber wall, where...

The Toolbox for the Modeling and Analysis of Thermodynamic Systems (TMATS) software package is a library of building blocks that can be assembled to represent any thermodynamic system in the Simulink® (MathWorks, Inc.) environment. These elements, along with a Newton Raphson solver (also provided as part of the...

Historically, parachutes have been load-tested by various methods including release from an aircraft, deploying in a wind tunnel, dragging through water, and shooting out of an air cannon. Each type of testing has its own advantages and drawbacks. Due to the loading mechanics particular to parachutes...

The area of research known as “Planetary Defense” is largely concerned with identifying and tracking asteroids that could impact Earth. The vast majority of asteroids that pose such a risk are known as “Near Earth Asteroids/Objects” or NEAs and NEOs. Some of them are unknown,...

Cryogenic fluid control valves require actuation that controls the geometric position of the orifice in a thermally stable manner. Traditional actuator devices may have various materials used in their construction that have varying CTEs (coefficients of thermal expansion) and therefore may...

The Crew Exploration Vehicle Parachute Assembly System (CPAS) project conducts computer simulations to verify that requirements on flight performance, parachute loads, and terminal rate of descent are met. The objective of this work was to obtain a high-fidelity simulation of Orion crew capsule flight test...

JPL has been hand-welding aluminum tubing for decades in support of flight programs and ground support equipment, including thermal plates and shrouds. This hand-welding process is time-consuming, cumbersome, difficult, and unreliable in terms of repeatability and success, which leads to leaks, rework,...

Cups/cones are being used to provide a shear load transfer capability on a large separation interface that uses multiple discreet retention and release (R&R) devices (such as frangible nuts, separation nuts, separation bolts, etc.). To both provide good...