Manufacturing & Prototyping

This technology exploits the capabilities of additive manufacturing to attenuate the fan noise within the inlet or aft duct of a turbofan engine. The approach may be expanded to include auxiliary power units, environmental control systems, or other...

The need for low-cost and environmentally friendly processes for fabricating printable electronics and biosensor chips is growing. Nanomaterials have proved to be very useful in both printable electronics due to their electronic properties, and in...

A new method was developed to prepare monodisperse nano to microparticles of polystyrene ranging from 0.5 to 2.5 microns in relatively large-quantity batches (2 L, 10% by weight in water). Current commercial sources are very expensive and can typically only be acquired on a...

The combination of electronic and mechanical properties of carbon nanotubes (CNTs) has led to wide-ranging investigation of their potential in future electronics and computing, sensors, electrodes, and composites. A method and system for fabricating an array of two or more CNT structures on a coated...

MIT Media Laboratory researchers are developing a wearable device that turns the user’s thumbnail into a miniature wireless track pad.

Engineers at NASA's Marshall Space Flight Center in Huntsville, Alabama, unboxed some special cargo from the International Space Station on April 6: the first items manufactured in space with a 3D printer.

The emerging interest in lunar mining poses a threat of contamination to pristine craters at the lunar poles, which act as cold traps for water, and may harbor other valuable minerals. Lunar Prospector type missions will be looking for volatile (molecular) compounds that may be masked by the exhaust...