A comprehensive library of technical briefs from engineering experts at NASA and major government, university, and commercial laboratories covering all aspects of innovations in electronics, software, photonics, imaging, motion control, automation, sensors, test, materials, manufacturing, mechanical, and mechatronics.

The proposed quantum receiver in this innovation partitions each binary signal interval into two unequal segments: a short “pre-measurement” segment in the beginning of the...

Briefs: Photonics/Optics
Cobra Fiber-Optic Positioner Upgrade

A prime focus spectrometer (PFS), along with corrective optics, will mount in place of the secondary mirror of the Subaru telescope on Mauna Kea, Hawaii. This will allow simultaneous observations of...

Briefs: Photonics/Optics
Practical UAV Optical Sensor Bench With Minimal Adjustability

A multiple-pass optical platform eliminates essentially all optical alignment degrees of freedom, save one. A fourpass absorption spectrometer architecture is made rigid by firmly mounting dielectric-coated mirror prisms with no alignment capability to the platform. The laser diode...

Solid-state lighting (SSL) is increasingly being introduced into the market and it is expected that many of the light sources currently used for general illumination will...

InfiniLED’s latest MicroLEDs (μLEDs) have produced record optical beam intensity. This new device is capable of producing up to 1mW of light from a single 20μm pixel at 405nm. This is...

Briefs: Lighting
Chips That Can Steer Light

If you want to create a moving light source, you have a few possibilities. One is to mount a light emitter in some kind of mechanical housing — the approach used in, for example, theatrical spotlights, which...

Briefs: Information Technology
Measurements of Ultra-Stable Oscillator (USO) Allan Deviations in Space

Researchers have used data from the GRAIL mission to the Moon to make the first in-flight verification of ultra-stable oscillators (USOs) with Allan deviation below 10–13 for 1-to-100-second averaging times. USOs are flown in space to provide stable timing...

Briefs: Physical Sciences
Rover Low Gain Antenna Qualification for Deep Space Thermal Environments

A method to qualify the Rover Low Gain Antenna (RLGA) for use during the Mars Science Laboratory (MSL) mission has been devised. The RLGA antenna must survive all ground operations, plus the nominal 670 Martian sol mission that includes the summer and winter seasons of the...

Briefs: Software
Gaseous Nitrogen Orifice Mass Flow Calculator

The Gaseous Nitrogen (GN2) Orifice Mass Flow Calculator was used to determine Space Shuttle Orbiter Water Spray Boiler (WSB) GN2 high-pressure tank source depletion rates for various leak scenarios, and the ability of the GN2 consumables to support cooling of Auxiliary Power Unit (APU) lubrication...

There are no existing ultra-sterile lab-on- a-chip systems that can accept solid samples and perform complete chemical analyses without human intervention. The proposed...

Briefs: Information Technology
Validation of Proposed Metrics for Two-Body Abrasion Scratch Test Analysis Standards

Abrasion of mechanical components and fabrics by soil on Earth is typically minimized by the effects of atmosphere and water. Potentially abrasive particles lose sharp and pointed geometrical features through erosion. In environments where such erosion does not...

Briefs: Information Technology
Measuring and Estimating Normalized Contrast in Infrared Flash Thermography

Infrared flash thermography (IRFT) is used to detect void-like flaws in a test object. The IRFT technique involves heating up the part surface using a flash of flash lamps. The post-flash evolution of the part surface temperature is sensed by an IR camera in terms of...

Briefs: Physical Sciences
Spectrally and Radiometrically Stable, Wideband, Onboard Calibration Source

The Onboard Calibration (OBC) source incorporates a medical/scientific-grade halogen source with a precisely designed fiber coupling system, and a fiber-based intensity-monitoring feedback loop that results in radiometric and spectral stabilities to within

Briefs: Manufacturing & Prototyping
High-Reliability Waveguide Vacuum/Pressure Window

The NASA Deep Space Network (DSN) uses commercial waveguide windows on the output waveguide of Ka-band (32 GHz) low-noise amplifiers. Mechanical failure of these windows resulted in an...

Technology has been developed for a class of self-contained, long-duration power sources called beta batteries, which harvest the energy contained in the...

Briefs: Manufacturing & Prototyping
Magnetic Shield for Adiabatic Demagnetization Refrigerators (ADR)

A new method was developed for creating a less expensive shield for ADRs using 1018 carbon steel. This shield has been designed to have similar performance to the expensive vanadium permen dur shields, but the cost is 30 to 50% less. Also, these shields can be stocked in a variety...

Briefs: Electronics & Computers
Adaptive Phase Delay Generator

There are several experimental setups involving rotating machinery that require some form of synchronization. The adaptive phase delay generator (APDG) — the Bencic-1000 — is a flexible instrument that...

Briefs: Electronics & Computers
CMOS-Compatible SOI MESFETS for Radiation-Hardened DC-to-DC Converters

A radiation-tolerant transistor switch has been developed that can operate between –196 and +150 °C for DC-to-DC power conversion applications. A prototype buck regulator component was demonstrated to be performing well after a total ionizing dose of 300 krad(Si). The...

Briefs: Electronics & Computers
Silicon Heat Pipe Array

Improved methods of heat dissipation are required for modern, high-powerdensity electronic systems. As increased functionality is progressively compacted into decreasing volumes, this need will be exacerbated. High-performance chip power is predicted to increase monotonically and rapidly with time. Systems utilizing these...

Briefs: Materials
High-Temperature, Lightweight, Self- Healing Ceramic Composites for Aircraft Engine Applications

The use of reliable, high-temperature, lightweight materials in the manufacture of aircraft engines is expected to result in lower fossil and biofuel consumption, thereby leading to cost savings and lower carbon emissions due to air travel. Although...

Briefs: Materials
Treatment to Control Adhesion of Silicone-Based Elastomers

Seals are used to facilitate the joining of two items, usually temporarily. At some point in the future, it is expected that the items will need to be separated. This innovation enables control of the adhesive properties of silicone-based elastomers. The innovation may also be effective...

Briefs: Materials
High-Temperature Adhesives for Thermally Stable Aero-Assist Technologies

Aero-assist technologies are used to control the velocity of exploration vehicles (EVs) when entering Earth or other planetary atmospheres. Since entry of EVs in planetary atmospheres results in significant heating, thermally stable aero-assist technologies are required to...

A new gripper mechanism can be used as an end effector for a long arm that reaches out from a nearby spacecraft for a touch-and-go type of mission. The gripper would stabilize...

Briefs: Mechanical & Fluid Systems
Rockballer Sample Acquisition Tool

It would be desirable to acquire rock and/or ice samples that extend below the surface of the parent rock or ice in extraterrestrial environments such as the Moon, Mars, comets, and asteroids. Such samples...

Briefs: Physical Sciences
Advanced Magnetic Materials Methods and Numerical Models for Fluidization in Microgravity and Hypogravity

To support long-duration manned missions in space such as a permanent lunar base, Mars transit, or Mars Surface Mission, improved methods for the treatment of solid wastes, particularly methods that recover valuable resources, are needed....

Briefs: Physical Sciences
Data Transfer for Multiple Sensor Networks Over a Broad Temperature Range

At extreme temperatures, cryogenic and over 300 °C, few electronic components are available to support intelligent data transfer over a common, linear combining medium. This innovation allows many sensors to operate on the same wire bus (or on the same airwaves or optical...

Briefs: Physical Sciences
Using Combustion Synthesis to Reinforce Berms and Other Regolith Structures

The Moonraker Excavator and other tools under development for use on the Moon, Mars, and asteroids will be employed to construct a number of civil engineering projects and to mine the soil. Mounds of loose soil will be subject to the local transport mechanisms plus...

A continuing challenge for modern instrument pointing control systems is to meet the increasingly stringent pointing performance requirements imposed by emerging...

Briefs: Physical Sciences
Visible-Infrared Hyperspectral Image Projector

The VisIR HIP generates spatially-spectrally complex scenes. The generated scenes simulate real-world targets viewed by various remote sensing instruments. The VisIR HIP consists of two subsystems: a spectral engine and a spatial engine. The spectral engine generates spectrally complex uniform...

Trending Stories

Briefs: Motion Control

Lightweight Crane Technology for the Moon

NASA Spinoff: Transportation

Nanotechnology Repairs Engine Damage in Cars

Briefs: Manufacturing & Prototyping

Artificial Intelligence Device Identifies Objects at the Speed of Light

Briefs: Mechanical & Fluid Systems

Materials Capable of Self-Propulsion

Application Briefs: Sensors/Data Acquisition

Military Optics Technology

Application Briefs: Sensors/Data Acquisition

Using the IoT for Predictive Maintenance

Videos